Manual

_, WARNING: Before performingany adjustment,

make surethe tool Is unpluggedfromthe power

supplyand the switchis in the OFF ( O ) position,

Failureto heed thiswarning could resultin serious

personalInfury.

The compoundmiter saw has been adjustedat the fac-

toryfor makingveryaccuratecuts. However,someofthe

componentsmight have moved out of alIgnmentduring

shlpplng,AJso,over a period of time, readjustmentwrit

probablybecome necessarydue to wear.After unpacking

the saw,check the following adjustments before you

beginusingsaw, Make any readjust_ants thatare

necessaryand per_odic_l_check the parts alignment

to make surethat the saw is cuffingaccurately.

POSITIVESTOP

ADJUSTMENT

SCREWFOR

OOAHBLES

PIVOT ADJUSTMENTS

NOTE: These edjusb'nerrtswere made at the factory and

normal_Jdo not requirereadjustment.

TRAVEL PIVOT ADJUSTMENT

• The saw arm shouldrisecompletelyto the up position

by itself.

• If the saw arm does not raiseby Itselfor if there Is play

inthe pivot.ioints,have sew repairedat yournearest

ServiceCenter.

BEVEL PIVOT ADJUSTMENT

• The compound mitersaw shouldbeveJeasilybyloos-

eningthe bevel lock knob and tiltingthe saw arm to the

left,

• If movementis tightor if thereis play in the pivot,have

saw repairedby a qualifiedservice technicianat your

nearestSearsService Centerto avoid dskof personal

injury,

DEPTH STOP

The depthstop isfactoryset to providemaximum cutting

capacity forthe 12 In. saw blade providedwith the saw,

LOCK

NUT(S)

Fig. 46