Manual

UNPACKING
This product requires assembly.
IJ Carefully lift saw from the carton and place it on a level
work sudace.
NOTE: This too! is heavy. To avoid back injury, keep
your knees bent and lift with your legs, nat your back,
and get help when reeded.
19 Inspect the took carefully to make sure no breakage or
damage occurred during shipping.
E1 Do not discard the pacldng material until you have
carefully iospected and satbfaetobty operated the tool.
The saw is factory set for accurate cutting. After
assembling it, check for accuracy. If shipping has
influenced the settings, refer' to specific procedures
explained in this manual
El if any parts are damaged or missing, please can
1-800-932-3188 for assistance.
_ WARNING: If any parts are missing, do not operate
this tool until the missing parts are replaced. Failure
to do so could result in possible seric)us personal
injury.
_ WARNING: Do not attempt to modify this tool
or create accessories not recommended for use
with this tool Any such alteration or modification is
misuse and could resull in a hazardous condition
leading to possible serious personal injury.
_ WARNING: Do not connect to power supply until
assembly is complete. Failure to comply could result
in accidental starting and possible serious personal
injury.
,_,_"_ WARNING: Do not lift the saw without help. Hold
it close to your body. Keep your knees bent and
lift with your legs, not your back. Ignoring these
precautions can ,esult in back injury.
_ WARNING: Never stand directly in line with the
blade or allow hands 10 come closer than 3 in. to the
blade. Do not reach over or across the blade Failure
to heed this warning can result in serious personal
illlLiry.
A WARNING: To avoid serious personal injury, always
make sure the table saw is securely mounted to
a workbench or an approved leg stand NEVER
operate the saw on the floor.
MOUNTING HOLES
This toot comes mounled to a leg stand. ]f you chose
remove the leg stand, the table saw must be mounted
firm _upporfing surface such as a worl_bench or leg sin _d,
Four bolt holes have been provided in the saw's basel
this porpose. Each of the four mounting holes should b
boll_ securely using 3/8 in. machine botts, lock wash_
and Nex nuts (not included). Bolls should be of sufficiei t
length to accommodate the saw base, lock washers, I_ _x
nuts, and the thickness of the workbench. Tighten all < ur
bolts securely.
Carefully check the workbench after mounting to make
sure that r_o movement can occur du[ng use. If any tip
ping, sliding, or we kirlg is noted, secure the workberi to
the fleer before operating.
TO INSTALLTHE BEVEL HANDLE ASSEMBL I
See Figure 6. I
r_ Lift the end cap off the bevel handle assembly using I a
flu i blade screwdriver. /
Ea Hdld [he nylon nut securely and turn the screw couoler-
clockwise to remove the nut completely
I
NOTE: Do not remove tile screw from the handle o:rlthe
washer from the end of [he screw.
i
/
Place the nylon nut into the recessed hole on the ba_,k
of ihe heightibevel adjusting handwheel arid hold in/
pl_ce, l
[] Slide the handle> screw, and washer into the hole on I[he
height/bevel ad _eting handwheeh /
B Using a flatlqead screwdriver, iul n the screw clockwise
and tighten in place. /
[] Push the end cap back in place on the end of the
handle.
NUT
BEVEL
ftEIGItTIBEVEL HANDLE
ADJUSTINGftANBWHEEL