Manual

TO CHECK SAW BLADE INSTALLATION
See Figure !2
CAUTION: To work properly, the saw blade teeth
must point down toward tile front o{ the saw. Failure
to do so could cause damage to the saw blade, the
saw, or the wcrkpiece.
NOTE: Arbor shaft has left hand threads.
Ia Lawer the saw blade and remove the throat plate.
M_ke sure the beret locking lever is securely pushed to
the left. Raise the saw blade to its full height by turning
the height!bevel adjusting handwheel clockwise.
To loosen the blade:
B Using the smalter blade wrench, place the flat open
end on the flats on the arbor shaft.
F_ insert the closed end of the larger bJade wrench over
the heY. nut. Holding both wrenches firmly, puff the
larger wrench forward to the front of the machine.
To tighten the blade:
_4 Using the smaller blade wrench, place the flat open
end ir_to the flats on the arbor shaft.
Insert the closed end af the larger blade wrench over
Lhe hex nut. Holding both wrenches firmly, push the
larger wrench to the back of the machine. Make sure
Lhe blade nut is securely tightened. Do not overtighten.
Check all clearances for free blade rotation. See To Set
the Scale to the Blade [n the AdjustmentsecUon, In
cutting operations, lhe scale will be set ta the side of the
blade where the cut wil! be measured and made.
LARGE
gLADE WRENCH
t SMALLBLADE
WRENCH
Fig. 12
i
TO INSTALL MITER FENCE
See Figure 13.
Remove the miter fence from the miter fence storafje
oh the side af the saw cabinet.
{a TOinstallthe miter lence to the eliding miter table, I)oos-
en the adjusting clamp knob so the bolt has enoug!l
clearance to slide into the table slot.
Mouot the miter fence to ihe miter tabte by instaliia_g
the locater pie (below the miter fence) into holes "A" or
, i
"B". At the same hme, place the attachment bolt h'l!the
!
slot.
Properly adiust the miter indicator to the scale an the
end af the fence apposite the Iocator pin,
_q Retighten the adjusting clamp knob.
MITERFENCE
HOLDER
MITER
iNDICATOR
TABEE
ATTACHMENT
BOLl
•LOCATIIR
PINJ
OUICI(STOP HOLE"A"
flDLE "B"
FirJ.t3
18