Manual

TOADJUSTTHEMITERBASE

See Figure 26.

Remember: Check a{I settings before loosening screws

for the following p:ocedures, Once screws have been

loosened, these settings must be reset.

_1 Unplug tits saw

O Sel the miter fence at O' then securely tighten the

Aaiusting Clarn_ Knob,

[] Push the stiding miter table te the back and loosen the

right-front screw from beneath the table saw cabinet.

LoOsen the ny_ock Nut beneath the f_m_t-le|t eocent_k;

screw.

8 Place one side of a framing square firmly against the

miter fer_ce and the ether side against the saw blade.

m Using s flalhead scnewdriver, turn the eccentric screw

ulltil the miter fence and the blade are square

Hold the eccentric screw in place wilh the screwdriver

and tighten the nylock nut securely

m Retighten the front right hand screw.

SLIDINGnITER MITERFENCE ECCENTR{C

SCREW

TABLE

TO CHECK MITER FENCE ALIGNMENT

See Figure 27,

The miter fence must be perpendic_llar to the blade w_!in

set at zero degrees.

O Set the miter fence (H) at 0 °. Miter indicator (I) shoulid

be set precisely on 0° and secured in place with

adjusting clamp (J).

NOTE'. The quick*stop is not necessary for this

checking procedure. However, you may want to cbedk

and adjust it to 0 _ at this time. See the To Adjust ,

Quick-Stop sectisn that follows.

e Place a framing square (G) !Jrmly against the miter

fence (H), with the other side against the blade (E).

[] Check whether the miter fence and blade are square

with each other. With the trarning square against the

relier fence there should be no gap from the front to

the rear of the brads.

B g a gap exists, the miter fence may be out of square, i

Rotate the blade and rechec £ If there is a consistelll j

gap between the froI_t and rear of the blade, the miter

table needs aligning. Follow the adjustment prooedurbs

that follow.

RIGHT

FRONT

SCREW