Manual

When the cut is made, turn the saw off. Wait Ior the
blade to come to a complete stop be[ore _emoving tire
workplace.
After the blade has stopped completely, remove the
cutoff stGck.
0 Grasp Ihe workplace from the lead end (the end fed
!/1o lhe blade first) and carefully remove it from the
table.
BEVELRIPCUT
BLADE
ANGLED
RiP FENCE
la Loosen tile lock knob on the miler gauge, sel the
gauge to the desired angle and tighten the lock km_
m Turn the power switch to the ON position.
B Position the workplace flat on the table with the ed
flush against the miter gauge. Let the blade build u
full speed before feeding Ihe workpiece into the bh
B Advance the workpieee a_d the miter gauge tower
the b!ade. Keep the workpiece flush against the mit
gauge. Push the miter gauge and wod_piece towar_
the blade. Stand slightly to the side of the wood as
it contacts the blade to reduce the chance of injury
should kickback occur.
o When the cut is made, turn the saw off. Wait for the
blade 1o come to a complete stop before removing
workplace.
o After the blade has stopped completely, remove th<
cutoff stock.
CO[VIPOUt,tD(BEVEL)PI'IITERCUT
PLACERIGHTHAND
ONWIIRKPIECEAilg
MITERG/_UGEHERE
tar
Fig. 42
MAKING A COMPOUND (BEVEL} MITER OUT
SeeFigure43.
It is recommended that you place the piece to be saved
on the left side of the blade and that you make ates[ cut
on scrap wood first.
_ WARNING: Make sure the blade guard assembly
is installed and working properly to avoid possible
serious injury.
8 Remove the rip fence by I]fting the lock down handle.
El Unlock the bevel Iocl{ing lever.
Adjust the bevel angle to the desired setting.
E_ LocI_ the bevel locking leven
o Set the saw blade to the correct deplh.
32
: " : ;- '7"