Manual

RULES FOR SAFE OPERATION (Continued)
24. OUTDOOR USE EXTENSION CORDS -- When tool is used 6u_do____, use only
extension cords suitable for use outdoors, Outdoor approved cords are marked
with the suffix W-A, for example -- SJTW-A or SJOW.A.
25. DON'T-- Place either hand in the cutting area when the saw is connected to the
electrical power supply, Accidental starting could result in serious personal in-
jury.
26. DON'T -- FORCE CUTTING ACTION. Stalling or partial stalling of motor can
cause major damage, Allow motor to reach full speed before cutting.
27, DON'T -- Use blades recommended for operation at less than 5500 RPM or of a
diameter not recommended. The use of improper blades may cause hazardous
operating conditions,
28. DON'T -- Attempt to cut small pieces, Injury could result from improper control
or clamping of such material,
29. DON'T -- Wedge anything against fan to hold motor shaft, This action will
cause serious damage to the saw motor,
30. DO -- Make certain the blade rotates in the correct direction, Incorrect rotation
will cause material "Kickback" and possible serious injury to operator,
31, DO -- Keep saw blade sharp and properly set to avoid blade cracking and grab-
bing, possibly resulting in a serious accident,
32. DANGER: A coasting cutting tool can be dangerous, To avoid possible serious
injury, apply brake immediately after completion of cut,
33. ALWAYS use identical replacement parts when servicing,
34. WEAR EYE PROTECTION.
35. KEEP HANDS OUT OF PATH OF SAW BLADE.
36, DO NOT OPERATE SAW WITHOUT GUARDS IN PLACE.
37. DO NOT PERFORM ANY OPERATION FREEHAND.
38. NEVER REACH AROUND SAW BLADE.
39, SHUT OFF POWER AND WAIT FOR SAW BLADE TO STOP BEFORE SERViC.
ING OR ADJUSTING TOOL.
40, WARNING: TO REDUCE THE RISK OF INJURY, RETURN SAW HEAD TO THE
FULL REAR POSITION AFTER EACH CROSSCUT OPERATION,
41, This tool is intended for residential use only,
42, SAVE THESE INSTRUCTIONS.
The operation of any miter saw can result in
foreign objects being thrown into the eyes, which
can result in severe eye damage. Always wear
safety goggles complying with ANSI Z87,1 (shown
on Package) before commencing power tool
or_eration. Safety Goggles are available at Sears
Catalog Order or Retail Stores,
TABLE OF CONTENTS
Unpacking ................................... 5
Mounting of Miter Saw ........................ 6
Assembly ................................... 6
Adjustments ............................... 7-9
Operating Instructions ..................... 10-11
Table Extension and
Securing Workpiece ....................... 11.12
Typical Operations ........................ 12-16
Maintenance ............................. 18-21
Trouble Shooting ............................ 22
illustration and Parts List ................... 25-31
How to Order Repair Parts .................... 32
p,,._ _ i_ 4