Manual

TOOLS HEEDED FOR ASSEMBLY AND ADJUSTMEHT
Your miter saw can be assembled and adjusted with a tow be$1c hand tools shown below:
?/16" AND 1/2" WRENCHES
3/i6" ALLEN WRENCH
(FURNISHED)
CRRFTSMRN
8" ADJUSTABLE WRENCH
BLADE WRENCH (FURNISHED)
MEDIUM SCREWDRIVER :
PHILLIPSSCREWI:_VER
E1',1i I, I'_ i, i ,1i i,'1 ' I, i,i,l'q_ ,I,ili, I,iii,i,i i i'i,l'l_
|l,/i,l,,_iii, i_,l_/,lli,l'l,i'ili,l,hl,],l'l
COMBINATION SQUARE
UNPACKING
,
Remove the miter saw from the carton by lifting it
by the miter saw table. See Figure 1. CAUTION:
When removing the miter saw do not lift by the
operating handle or the saw arm as this may
Cause misalignment.
2. Remove the two hex nuts and washers and lift the
miter saw off the cardboard pad.
3, Your miter saw is shipped with the saw head lock-
ed both in the rear positron and the 45 ° miter set.
ting. To release the saw head, unlock by turning
the lock lever counter-clockwise, This will allow
the saw head to move forward for operating pos.
itions, Move the saw head through its entire
movement, front to rear. several times to check
for binding, Should saw head bind in its move.
merit, make adjustment as follows: See Fig. 1
1, Move saw head to futl rear position.
2. Using allen wrench furnished, loosen
screw (A) on front guide rod clamp, one
half turn.
3. Move saw head through its entire move
ment, front to rear several times, stopping
it in the front position,
4, Move the saw head slightly to the rear and tighten
screw (A) securely,
5. Recheck for any binding in saw head
movement.
Should binding Still be present after adjusting,
return the saw to your nearest Sears retail store. See
Page 11 for operating instructions of miter arm,
BEVEL
LOCK_
,-LOCK LEVER
BurToN
ATING HAHDLE
\
Fig, 1
Page 5