Manual

Hold tool by insulated gripping surfaces when perfomning an operation where the cutting tool may contact
hidden wiring or its cord. Contact with a "live" wire will make exposed metal parts of the tool "five" and shock the
operator.
Additional Rules for Safe Operation
• Know your power tool. Reed operator's manuel
carefully. Learn itsapplications end limitations, as
well as the specific potential hazards related to
this tool, Followingthis rule will reduce the risk of
electricshock,tim, or sedousinjury.
• Always wear safoty glasses. Everyday ayeglaeses
have only impact.rcaistant lenses; they are NOT
safety glasses. Followingthis rulewill reducethe risk
of seriouspersonalInjury.
• Protect your lungs, Wear a face or duat mask if the
operation isdusty. FollowingthisnJtewillreducethe
riskof serious personalinjury,
• Protect your hearing. Wear hcadeg protection
dudng extended periods of operation, Following
thisrulewillreducethe riskofseriouspersonalinjury.
• Inspect tool cords pedodicelly and, if damaged,
have repaired at your nearest Factory Service
Center or other Authorized Service Organiza-
tion. Constantly stay aware of cord location.
Followingthis rulewill reducethe riskof electric
shock orfire.
• Check damaged perle. Before furlher usa of the
tool, a guard or other pad that is damaged
should be carefully checked to determine that it
will operate propedy and perform its intended
function. Check for alignment of moving pelts,
binding of moving peas, breakage of parts,
mounting, and any other conditions that may
affect its operation, A guard or other pelt that is
damaged should he properly repaired or replaced
by an authorized service center. Followingthis
rulewillreducethe dsk of electdc shock,fire, or
seriousinjury.
• Don't abuse cord. Never cam] the tool by the
cord or yank it to disconnect it from the recep-
tacle. Keep cord away from heat, oil, and sharp
edges. Followingthis rule will reducethe riskof
electric shockor fire.
• Make sure your extension cord is in good
condition. When using an extension cord, be
sure to use one heavy enough to cam] the
currant your product will drew. A wire gage size
(A.W.G.) of at least 16 is recommended for an
extension cord 100 feet or less in length. A cord
exceeding 100 feet is not racommended. If in
doubt, use the next heavier gage. The smaller
the gage number, the heavier the cord. An
undersizedcordwillcause a drop in linevoltage
resulting in lossof powerand overheating.
• Inspect for and remove all nails from lumber be-
fore drilling. Followingthisrulewillreducethe riskof
seriouspersonalinjury,
• Drugs, alcohol, medication. Do not operate tool
while under the influence ofdrugs, alcohol, orany
medication. Followingthisrulewillreducethe risk of
electdc shock,fire, or seriouspersonal injury.
• Save these instructions. Refer to them frequently
and use them to instruct others who may usethis
tool. If you loan someone this tool, loan them
these instructions also.
A WARNING: Some dust created by power
sanding, sawing, grinding, drilling,and other
constructionactivitiescontains chemicals known
to cause cancer, birth defects or other
reproductiveharm. Some examples ofthese
chemicalsare:
lead from lead-based paints,
crystalline silicafrom bricks and cement and
other masonry products, and
• arsenic end chromiumfrom chemically-
treated lumber.
Your risk from these exposures varies,
depending on how oftenyou do this typeofwork.
TO reduce your exposure to these chemicals:
work in a well ventilated area, and work with
approved safety equipment, such as those dust
masks that are specially designed to filter out
microscopicparticles,