Operator`s manual

5
KNOW YOUR UNIT
INSTALLING / REMOVING THE ATTACHMENT
Installing the attachment:
NOTE: To make installing or removing the attachment easier, place
the unit on the ground or on a work bench.
1. Remove the hanger from the top of the shaft housing.
2. Turn knob counterclockwise to loosen (Fig. 1).
3. While firmly holding the attachment, push it straight into the coupler
until the release button snaps firmly into the primary hole (Fig. 2).
NOTE: Aligning the release button with the guide recess will help
installation (Fig. 3).
WARNING:
Read and understand operator’s manual
for unit to be used with this attachment prior to
operation.
WARNING:
To avoid serious personal injury and
damage to the unit, shut unit off before removing or
installing attachments.
Primary Hole
Upper Shaft
Housing
Craftsman Convertible™
Coupler
Fig. 2
Lower Shaft
Housing
Release Button
Knob
4. Turn the knob clockwise to tighten (Fig. 1).
CAUTION:
Lock the release button in the primary
hole (Fig. 2) and securely tighten the knob before
operating this unit.
CAUTION:
The attachments with the coupler system
are to be used in the primary hole only. Using the wrong
hole could lead to personal injury or damage to the unit.
Fig. 1
Knob
Adjustment Bolt
Drive Shaft
Assembly
Angle
Adjustment
Handle
Blade
Indexing Ring
Tighten
Loosen
ASSEMBLY INSTRUCTIONS
Release Button
Guide Recess
Knob
Fig. 3
WARNING:
DO NOT USE an extension boom with
this product. It is not designed to be used with an
extension and using one may cause serious injury.
Hanger
Craftsman Convertible™
Coupler
Gear Housing