Operator’s Manual CRAFTSMAN 4-Cycle BACKPACK BLOWER Model No. 316.794010 INCREMENTALISM UNBELIEVABLE STARTING EASE * SAFETY *» ASSEMBLY * OPERATION * MAINTENANCE * PARTS LIST » LIFESPAN, P 13 CAUTION: Before using this product, read this manual and follow all safety rules and operating instructions. Sears Brands Management Corporation, Hoffman Estates, IL. 60179 U.S.A.
RULES FOR SAFE OPERATION TABLE OF CONTENTS Rules for Safe Operation. Warranty Information Know Your Unit... Assembly Instructions Cll and Fuse information Starting/Stopping Instructions Operating Instructions . Maintenance and Repair Instructions Cleaning and Storage Troubleshooting Specifications Parts List... Service Information SPARK ARREST OR NOTE NOTE: For users on U.S. Forest Land and in the states of California, Maine, Oregon and Washington, All U.
RULES FOR SAFE OPERATION OTHER SAFETY WARNINGS fot run the engine at high sped when not in Lie. Always stop the engine wham op station is delayed or wham walking from one location to another. Stop the engine for maintenance, repair, to install or overate the blower tubes. The unit must be stopped and the impeller no longer turning to avoid contact with the rotating blades. If you strike or come Into contact with a foreign object, stop the engine immediately and check for damage.
WARRANTY STATEMENT CRAFTSMAN 2 YEAR FULL WARRANTY FOR 2 YEAR(S) from the date of purchase, this product is warranted against any defects in material or workmanship. Defective product will receive free repair or free replacement i repair is unavailable, For warranty coverage details to obtain repair or replacement, visit the web site’ www craftsman.
ASSEMBLY INSTRUCTIONS ASSEMBLING THE BLOWER TUBE Adjusting the Throttle Grip Throttle Ts i 1. Move the throttle grip lo a onto WARNING: To avoid serious personal injury and carnage to the unit, shut the unit off fora removing or installing the blower tubes. location on the upper blower tube that provides the best rip (Fig. 6). Installing the Flex Tube FRA Ew 2. Using a 7:20 Torx® es 1. Place a hose clamp over the “deer screwdriver, tighten the two pa and of the Flex Tube (Fig. 1).
Oil. AND FUEL INFORMATION RECOMMENDED OfL TYPE Using the proper type and weight of ofl in the crankcase is extremely important, Heck oll before sate use while the engine Js cold and change the ofl per the Maintenance Schedule. Failures to use the correct ofl, or using dirty oil, can cause premature engine wear and failure. Use a high-quality SAE 30 weight ofl of AP! {American Petroleum Institute) service class SF. 5G, SH. ADDING OIL. TO CRANKCASE: INITIAL USE NOTE: This unit is shipped without oil.
STARTING/STOPPING INSTRUCTIONS OPERATING INSTRUCTIONS 8 Squeeze and hold the throttle control and allow the engine to warm up for 30 to 60 seconds. 9 Continue to squeeze the Starter Rope throttle control. Move the choke lever to Position 3 {Fig. 12) and continue warming the engine for an additional 60 seconds. During this time the unit may be used the engine does not stein, go back to step 3. § y ff. the engine fails 10 start after Fig.
OPERATING INSTRUCTIONS MAINTENANCE AND REPAIR INSTRUCTIONS Watch out for children. pets, pan windows or freshly washed cars, and blow debris safely away. Us the full blower nozzle extension so the alr stream can work closer to the ground. Clean up after using blowers and other equipment. Dispose of debris appropriately. Us the cruise control (Fig, 15) to keep tha trigger depressed while operating to make continuous operation easier.
MAINTENANCE AND REPAIR INSTRUCTIONS Adjusting Nuts Adjust (dle Speed Screw WARNING: The unit will be running during die speed adjustments, Wear protective clothing and observe all safety instructions to prevent serious personal injury. 1, after checking the fuel and cleaning the alr filter, the engine still will not idle. adjust the die speed resew as follows: 1. Sat the engine and let it run at a high idle for a minute 10 warm up. Refer to Ade ot y batmen Starting/Stopping ren Instructions. 2.
MAINTENANCE AND REPAIR INSTRUCTIONS CLEANING Use & small brush to clean off the outside of the unit. Do not use strong detergents, Household cleaners that contain aromatic oils such as ping and lemon, and solvents such as kerosene, can damage plastic housing or handle. Wipe off any moisture with a soft cloth. STORAGE Never store the unit with fue in the tank where fumes may reach an open flame or spark. Allows the engine to cool before storing. Lock up the unit ta prevent unauthorized use or damage.
TROUBLESHOOTING PROBLEM ENGINE WILL NOT START SOLUTION Empty fuel tank Milf fuel tank with fuel a 1 tis pid nib iv ans iii.
SPECIFICATIONS Engine Type... . Air-Cooled, 4-Coyle Displacement, 1.9503 (32 ec} Operating RPM |, rpm Idle Speed RPM. rpm Tuition Type. . . . Electronic Ignition Switch. . Ceres Coe FE . . Coe Coe Rocker Switch Valve SIBERIAN. Loot ti eee ee 0 002-0 006 in. 0 mm} Spark PUG Gap iii. Q028 inch (0.835 mm) Lubrication . .. SAE 30 Git Crankcase Gil Capacity . . 3.
NORMAS PARA UNA OPERACIÓN SEGURA INDICE DE CONTENIDOS Normas [azar una operacional segura . Garantía . Cornea su unidad . 14 16 S16 Instrucciones de montaje a7 Información del aceite y del combustible... Y. Instrucciones de angustiar y apagado Contraportada Instrucciones de operación instrucciones de mantenimiento y reparación . Limpieza y malmarriento . Resolución de problemas . Especificaciones Lista de piezas .
NORMAS PARA UNA OPERACIÓN SEGURA No fuerces la unidad, Ara mejor ef trabajo y con menos probabilidad de lesión bajo fa tesa de funcionamiento que fue disecada, No alcance més da la cuenta nial use desde superficies inestables tales como escaleras, arboles, lomas muy inclinadas, techos, ete. Observe siempre una posición firme y balanceada, Sostenga siempre fa unidad con ambas manca mientras esté en funcionamiento. Mantenga las manos, la cara y los pies lejos de todas las partes moviese.
INSTRUCCIONES DE MONTAJE ENSAMBLAJE DEL TUBO DE LA SOPLADORA Ajuste del mango de control del regulador ADVERTENCIA: Para avilar [sisones personales graves y 1. Musca el mango de control Taso Pisad daos a la unidad, apague la unidad antes de guitar o instalar ef del regulador a Ln lugar en el superior regulador tbo de la sopladora, tubo superior de la sopladora SR, que le queda cómodo a Instalación del tubo flexible Usted (Fig. 6). manguera sobre el extrema Toro” A-20, apriete los dos del tbo flexible (Fig.
INFORMACIÓN DEL ACEITE Y DEL COMBUSTIBLE TIPO DE ACEITE RECOMENDADO El uso de un aceite del tipo peso correctos en ef encinal es extremadamente importante. Verifique ef aceite antes de cada usc y cambe ¢l aceite con frecuencia, Sino usa el aceite correcto, 0 utiliza aceite sucio, puede causar ef desgaste y tal prematuras del motor Use un aceite de buena calidad SAE 30 de API (Amaricen Petrolero Instituye} clase de servicio 5G, SF, SH.
INSTRUCCIONES DE ARRANQUE Y APAGADO 5 Comuníquese sn la posición de Gusta a arranque (Fig. 14). No manque exprima et control de válvula reguladora, Tire de la cuerda de arranque 8 veces en un movimiento controlada. 6. Golosos la palanca def laboratorio en la Posición 2 {Fig. 13). 7. Tire de la cuerda de arraigue 3 a 5 veces en Un movimiento controlado para arrancar el motor. 8 Apriete y sostenga of gatillo y permitir guié sl rotor se caliente durante 30 a 60 segundos. 9. Continuar oprima el gratifico.
INSTRUCCIONES DE OPERACIÓN INSTRUCCIONES DE MANTENIMIENTO Y REPARACIÓN CONSEJOS ÚTILES SOBRE LA OPERACIÓN VERIFICACIÓN DEL NIVEL DE ACEITE ADVERTENCIA: Para vitar lesiones personales graves ¢ dacio a la unidad, asegúrese de que los tubos de la sopladora & estén colocados antes de hacer funcionar la unidad, A ADVERTENCIA: Para evitar graves lesiones personales, ‘apagues siempre Su recargador y Espere que se enfrié antes de limpiarlo © realizar todo ipa de mantenimiento, Asegúrese que la unidad no apunte haci
INSTRUCCIONES DE MANTENIMIENTO Y REPARACIÓN 4. Aplique suficiencias aceite lirio de motor SAE 20 para reclinar ligeramente el filio / {Fig. 25}. 2 5. Apriete df filtro para esparcir y retirar el exceso de somete Fig. 26). 8. Vuela a colocar of filo (Fig, 23) NOTA: Sopera la unidad sin el tritio de aire, su garantía ser ANULADA. 7. Instrumental la cubierta del filtro de aire. Coloques ios ganchos del lado derecha de la cubierta dat filtro de aire en fas ranuras del lado derecha de Ia placa posterior (Figos.
INSTRUCCIONES DE MANTENIMIENTO Y REPARACIÓN INSTRUCCIONES DE MANTENIMIENTO Y REPARACIÓN 12. Vulva a instalar Ia cubierta del motor. Verifique 1a alineación de 1a cubierta antes de ajusta los torillos. Ajuste los libratorios. CAMBICE DE LA BUJÍA DE ENCENDIDO Use una Champan RDZ4H o bujía de encendido 7563-05784. La separación correcta es de 0.635 mm (0.025 pulga. Retire la bula per Programa de mantenimiento 6 inspeccionas si estado. 1.
ESPECIFICACIONES Ele: Tipo de motor Desplazamiento. f.8M. de operación COLMAR. de velocidad mínima Tipo de encendido . . . interruptor de encendido . Huelgo de la válvula Separación de Ia bujía de encendida Lubrican Capacidad de ace . Enfriado por aire, 4 ciclos . 32 co {1.96 pulgadas cubicas) 1.p.m) rpm. Electrónico Interruptor oscilante 0076-0152 ma pulga} . 0.635 mm {0.025 pulga} . Aceite SAE 30 90 mil {3.04 onzas) te del cárter del encinal Combustible sin plomo Carburador.
PARTS LIST fem Part No. 753-05669 Te-182361 TE 3-0667C 791-181025 753-05671 753-05672 75205784 752-05673 753-05248 753-05674 Te-181003 TEE-06675 TEE-06676 791-181751 753-05253 752-05852 T52-05677 752-05870 Description Muffler Assembly (includes 2 & 3} Muffler Screw Muffler Gasket Craw Rocker Cover Rocker Cover O-Ring Spark Plug Insulator Gasket Nut Insulator Resew Carburetor Gasket Carburetor Carburetor O-Ring Se raw Alr Cleaner Assembly {includes 16} Air Filter Throttle Cable REPLACEMENT PARTS MODEL 316.
PARTS LIST REPLACEMENT PARTS MODEL 316.794010 4-CYCLE BACKPACK BLOWER tem Part No. Description tem Part No. Description 1 753.08001 Flared Nozzle 14 75304505 Screw 2753-05971 Lower Blower Tube 15753-08658 Impeller Housing Assembly 3 753-08075 Throttle Grip Assembly 16 791-180050 Nut 4 753.
Your Home For troubleshooting, product manuals and home solutions advice: @® manageability www.managemylife.com For repair — in your home — of all major brand appliances, lawn and garden equipment, or heating and cooling systems, no matter who made it, no matter who sold it! ! For the replacement parts, accessories and i owner's manuals that you need to do-it-yourself. For Sears professional installation of home appliances and items like garage door openers and water heaters.