Instruction manual

SAFETY INSTRUCTmONS CONTINUED
11 ALWAYS WEAR EYE PROTECTION. Any Sander can throw foreign objects into the
eyes which could cause permanent eye damage ALWAYS Wear Safety
WEARYOUR Goggles (not glasses) that comply with ANSI safety standard Z87o t,
Everyday eyeglasses have only impact-resistant lenses._ they ARE NOT
safety glasses Safety Goggles are available at Sears,
NOTE: Glasses or goggles not in compliance with ANSI Z87,1 coiald
seriously hurt you when they break,
12_ AVOID ACCIDENTAL STARTING.
Ensure that the power switch is in the
"OFF" position before plugging in the
power cord
13, REMOVE ADJUSTING TOOLS. Form
habit of checking to see that tools and
adjusting wrenches are removed from the
sander before turning it on_
14_ USE ONLY RECOMMENDED
ACCESSORIES. Using improper
accessories can be hazardous. If in doubt,
check the instruction manual that comes
with that accessory,
t9, CHECK DAMAGED PARTS. Before
each use of tool, a guard or other part that
is damaged should be carefully checked to
determine that it will operate properly and
perform its intended function. Check for
alignment of moving parts, binding of
moving parts, breakage of parts, mounting
or any other conditions that may affect its
operation, A guard or other part that is
damaged should be properly repaired or
replaced°
20_ MAKE WORKSHOP CHILDPROOF.
By use of padlocks, master switches, or by
removing starter keys_
15, NEVER LEAVE A TOOL RUNNING
UNATTENDED. Turn the power switch
to "OFF", DO NOT leave too! until it has
come to complete stop
16. NEVER STAND ON A TOOL. Serious
injury could result ff the tool tips or you
accidentally hit the sander, DO NOT
store anything above or near the toot
where anyone might stand on the tool to
reach it
17. DON'T OVERREACH. Keep proper
footing and balance at all times. Wear
oil-resistant r_ubber_soted footwear. Keep
floor clear of oil, scrap and other debris
18. MAINTAIN TOOLS WITH CARE.
Always keep tools clean and in good
working order
21,
22
23
24
DRUGS, ALGOHOL OR
MEDICATIONS. DO NOT operate tool if
you are under the i_n£1uence of drugs,
alcohol or medication that could affect
3,our ability to use the tool properly,
SECURE ALL WORK. When practical,
use clamps or a vise to hold work, It is sager
than using your hands and prevents round
or odd-shaped pieces from turning.
, DIRECTION OF FEED. Feed work into a
blade or cutter against the direction of
rotation of the blade or cutter ordyo
WARNING: Dust generated from certain
materials can be injuriou s to your health.
Always operate sander in well ventilated
areas and provide for proper dust removal
SAVE THESE INSTRUCTIONS
Page 3