Operator`s manual

INTERNAL ROUTING WITH PLUNGE BASE (Flgso 19 and 19a)

1 Wilhdeplh-of_culset, andlhoplungeactionlockedtntheralsed{Up)poslgon,

lure motor "On" and lel motor build up to itslull speed (see Fig 19)

2 To begin yourcul, unlock the plunge lock lover and gsntlylowar the plunge action

down evenlyInto the workpiece(see Fig 19a)

Feed Direction

3 When the desired depth-of-cut is achieved, lock the plunge lock lover (Down) and

proceedto make your cut(see Fig ! 9a)

4 When cut Iscompleted, turn motor"Off" and lel cotter bit come toa complete slop

5 When culler bit comes to a comptele stop, unlock plunge look lever (Up) and ptunge

action willautomatically reiract cutter bit from workplace

, Z_ WARNING: Removing cutter bit from workplace while It is stl!l rotetlng

could damage workplace end result In loss of control, causing serious personal

injury.

6 Unplug router :from power source, piece router on workiable, Inspect flnlehed cut

in workplace

i Z_ WARNING: Always securely clamp your workplace and keep a firm grip

on the router base with BOTH HANDS st eli times, Failure to do so could result

tn toss of control causing possible serious personal injury°