Operator`s manual

Z_ WARNING; For your safety, ALWAYS turn off switch and unplug reuter

motor from the power source before performing any maintenance or cleaning

Ithas been foundthatelectric tools are subject Io accelerated wear and possible

premature lallure when theyare used 1oworkon fiber glass boats and sports cars,

wallboard, spackling compounds or plaster The chipsand gdndlngs from thesematerials

are highlyabrasiveto electricaltoolparis, such as bearings,brushes, commutators,elc

Consequenl}y, it is not recommendedlhat Ibis toot be used forextended work on any

fiberglassmaterial, wallboard, spackling compound or plaster,During any use on these

materials, tt is extremely Imporlanl that the tool Is cleanedfrequently by blowing with

an air jet

Z_ WARNING: Always wear safety goggles or safety glasses with side shields I

during power Iool operallons, or when blowing dust, If eparelton Is dusty, also

wear a dust mask,

ROUTINE MAINTENANCE

Z_ WARNING: DO NOT at any time let brake flulda_ gasoline, petroleum-based

products, penetrating oils, sic. come in contact with plastic parts, Chemicals can

damage, weaken or destroy plastic, which may result in serious personal Injury°

1 When work has been compleled, clean the tool to aflow smoolh functioning of the

toolever llme

2. Use cleandamp dolhs towipe the tool

3, Check the slate of all electrical cables

4 Keep the motor air openings free irom o_L grease and sawdust or woodchlps, and

store fool in a dr,i place

S Be certain that all moving parts ere well lubricated, padlcular[y after tenglhy exposure

to damp and/or dldy conditions

_ WARNING: For your salety_ ALWAYS turn off switch and unplug router

motor from the power source before performing any maintenance or cleaning,

Reler 10Cutlet/Nut Care and Cutter Bits on page t6 for cleaning care