Operator`s manual

SELECTING THE CORRECT SOCKET (SOCKETS AVAILABLE SEPARATELY)

_, CAUTION: Always verifythat the tool is switched off and unplugged before

installing any accessories on the tool.

Always use the correct size socket for bolts and nuts. An incorrect socket will

result in inaccurate and inconsistent fastening torque and/or damage to the bolt

or nut.

INSTALLINGAND REMOVING THE SOCKET (Fig.2)

1. To install the socket, push it onto the

output drive of the tool until it locks into

place.

2. To remove the socket, simply pull it off.

TURNING THE IMPACT WRENCH ON (Fig, 3)

Fig. 2 _r_------_j /

Socket

Output

Drive

Connect the power cord of your impact

wrench to a standard household power

outlet.

Fig. 3

2. Press the part of the switch marked _F_,

to run the tool in the forward direction

(clockwise rotation). Use this direction for

tightening bolts or nuts.

Switch

3. Press the part of the switch marked _-R_

to reverse the motor direction (counter-

clockwise rotation). Use this direction for

loosening bolts or nuts.

4. Release the switch to stop the tool.

5. Keep the switch pressed for continuous operation.

_, CAUTION: Do not allow familiarity with your impact wrench to make you

careless. Remember that a careless fraction of a second is sufficient to cause

severe injury.

27990 ManuaLRevised_lO ±202 Page 12