Instruction Manual

To adjust Depth with the Depth-Adjustment Wrencfi (Fig. 21}
NOTE: The Depth-Adjustment
Wrench supplied is used to
adjust the depth of cut when
the router fixed to the router
table (Model No. 320.28180).
The bit depth can be adjusted
by turning the Micro Adjust
ment Dial clockwise or coun
terclockwise with the wrench
supplied. The depth of the
cut can be read on the scale
dial. Each mark on the scale
indicates a 1/64 in. change in
depth setting.
1. Switch off the router.
2. Loosen the router motor clamp.
3. Insert the wrench into the adjusting hole on the table top, turn the adjustment
knob clockwise with the wrench to move the collet (down, or counterclock
wise to move the collet up..
4. When the desired depth of cut is set, tighten the cldmping lever.
28190 Manua!_Revisec!_074M09
Page 32