Instruction Manual
. CAUTION: Keep the extension cord clear of the working area. Position
the cord so that it will not get caught on lumber, tools or other obstructions
while you are working with a power tool.
WARNING: Check extension cords before each use. If damaged replace
immediately. Never use tool with a damaged cord since touching the dam
aged area could cause electrical shock, resulting in serious injury.
SAFETY
TTie label
V
......
.
....
A...
....
.....
Hz...
.......
.
W
...........
min
......
.
SYMBOLS FOR YOUR TOOL
on your tool may include the following symbols.
.......
........
.
..........
.
..............
Volts
,.,/min...
...Amps
..Hertz
..Watts
..Minutes
..Alternating current
..Direct current
...No-load speed
..Class II construction, Double Insulated
..Revolutions or Strokes per minute
. Indicates danger, warning or caution. It means
attention! Your safety Is involved.
SERVICE SAFETY
• If any part of this router is missing or should break, bend, or fail In any way;
or should any electrical component fail to perform properly: SHUT OFF the
power switch and remove the router plug from the power source and have the
missing, damaged or failed parts replaced BEFORE resuming operation,
» Tool service must be performed only at a Sears Parts and Repair Center.
Service or maintenance performed by unqualified personnel could result in a
risk of injury.
• When servicing a tool, use only identical replacement parts. Follow in
structions in the maintenance section of this manual. Use of unauthorized
parts or failure to follow maintenance instructions may create a risk of electric
shock or injury.
28190 Manual Revised 070409
Page?