Operator`s manual

USING THE LASER TRAC TM
LIGHT FEATURE (Fig. 9a)
Your jig saw has a built-in laser
light. To activate the laser, plug
in your jig saw.
_, WARNING: Laser light.
Laser radiation. Avoid direct
eye exposure. Do not stare into
beam. Only turn laser beam on
when tool is on the workpiece.
Class II laser.
1.
i i
Fig. 9a
Mark the line of cut on the
workpiece.
2. Adjust the cutting angle
and cutting speed as needed.
3. Plug in the saw, and push the laser button to turn on the laser.
4. Align the laser beam with the line of cut.
5. Turn on the trigger switch and slowly push the saw forward, keeping the
laser beam on the line of cut.
6. Shut off the laser light when finished cutting.
LED WORKLIGHT
Your jig saw has a built-in LED worklight for illuminating the cutting area. To
activate the LED worklight, plug in your jig saw. The LED worklight turns on
automatically when the tool is plugged in power source.
"LIVE TOOL iNDiCATOR"
LED LIGHT (FIG. 9B)
Your jig saw has a "live tool
indicator" green LED light,
located where the power cord
enters the handle. This light turns
on automatically when the saw is
plugged into a power source.
-Fig. 9b
Live tool indicator LED light
28223 ManuaLRevised_10 0310 Page 19