Operator`s manual

TO ADJUST BASE PLATE FOR BEVEL CUTTING (Figs. 18 19)
AL_ CAUTION: Always remove the blade before adjusting the cutting angle.
,_k CAUTION: To prevent damage to the tool when angle or bevel cutting, the
scroll mechanism must be locked in place with the cutting edge of the blade facing
the front of the tool.
1. To adjust the cutting
angle, first turn the tool
upside down.
2. Use the hex key to loosen
the hex screw securing the
saw base.
3. Move the base of the saw
slightly forward and tilt
it to the required angle
between 0° and 45 °, using
the scale marked on the
base bracket.
4. Install a cutting blade.
5. 5. Slide the blade guide
assembly until the blade
guide rests against the
back edge of the blade.
6. Re-tighten the hex screws.
For accurate work, it is
necessary to make a trial cut,
measure the work and reset the
angle until the correct setting is
achieved
_, WARNING: Do not let
familiarity with your saw make
you careless. Remember that a
careless fraction of a second is
sufficient to cause severe injury.
Fig. 18
28223 ManuaLRevised_lO 0310 Page 26