Operator`s manual

PROBLEM CAUSE SOLUTION
Laser line is not Laser is not turned on, or Make sure that the tool
projected, the tool is not plugged in. is plugged in, and press
Laser ON/OFF button to
turn laser on.
Working condition is too Reduce surrounding
bright, light level.
Laser line is hard to
see.
LED worklight does not
illuminate.
The Scrolling Control
Knob cannot be turned.
LED worklight illuminates
automatically when tool is
plugged in. Check to see
if tool is plugged in.
The Scrolling/Orbital
Control Lever is not set to
the Scrolling position.
Plug tool in. LED
worklight illuminates
automatically once tool
is plugged into electrical
source.
Set the Scrolling/Orbital
Control Lever to the
Scrolling position.
28223 ManuaLRevised_10 0310 Page 31