Operating instructions

ADJUSTING THE LASER LINE PROJECTION (See Figure 5)

The laser line projected from

this tool can be adjusted 90 °

from vertical to horizontal and

all angles in between,

Use the black finger knob on

the top of the tool to adjust

angle,

1. Turn the tool on and be

careful not to point the tool

in the direction of

anyone's eyes.

2. Move the finger knob in

either direction to change

the angle of the laser line

on any surface directly in

front of the tool.

Fig. 5

USING THE MAGNETIC BASE (See Figures 6 and 7)

The Laser Trac TM Level has a magnetic base (see Fig. 6) that can be used with

either the Thin-Pin Wall-Mount Base or the Precision Leveling Base (see Fig. 7).

The magnetic base allows the tool to be mounted on any coated or uncoated

13/4x 4-in flat steel surface. This feature is particularly handy for working on steel stud

framework and duct_,_lork.For further instructions on the use of this tool with the

base plates see Using the Laser Trac TM Level section of this manual,

un,, i,lll,ll,,,,H,_, ............ i i,lll,ll i,llL,,, uH,,,,lln,,lll ,i,tl

Magnetic Base

Fig.

Fig. 6