Manual

TURNTHE LASER LIGHT "ON/OFF' (Fig. 10)
Your sabre saw has a built-in laser light.
To activate laser light, plug inyour sabre saw.
SAFETY PRECAUTIONS FOR LASER
This saw has a built-in laser light. The laser is a
Class Ilia and emits output power of a maximum
2.5roW and 650nm wavelengths. These lasers do not
normally present an optical hazard. However,
DO NOT stare at the beam because itcan cause
flash blindness.
IMPORTANT: The following label is on your saw.
It indicates where the laser light is emitted by the saw. ALWAYS BE AWARE of its location
when using the saw, ALWAYS MAKE SURE that any bystanders in the vicinityof use are
made aware of the dangers of lookingdirectlyinto the laser.
Z_WARNING[ LASER LIGHT. LASER RADIATION. Avoid Direct Eye Exposure.
Do NotStare into beam.Onlyturnlaserbeamonwhen toolisonthe workplace.Class ilia.
Z_CAUTION: The tinted glasses thatwere includedwill enhance the laser light in bright
lightconditions.DO NOT wear these glasses ifthey interferewith the safe operationof
ths saw.
1.Move the LASER/LED switchto the "LASER LINE" position.The laser lightwillbe
projectedout from the laser aperture (See Fig. 10). Use the laser lineas cuttingline
guide by focusing iton a fixed "target" and following its path.
2. To turnoff the laser light, move the LASER / LED switch to the "OFF" position.
TURN THE LED WORK LIGHT "ON/OFF" (Fig. 10)
Yoursabre saw has a built-in LED work light (See Fig. 10) for illuminatingthe cutting area.
To activatethe LED work light, plug inyour sabre saw.
1. Move the LASER/LED switch to the "LED" position.The LED lamp will come on.
2. To turnoff the LED work light, move the LASER / LED switchto the "OFF" position.
14