Manual

TO ADJUST BASE PLATE FOR BEVEL CUTTING (Figs. 17, 18)

I _ CAUTION: To prevent damage to the tool when angle or bevel cutting,the scroll

mechanism MUST BE locked in place withthe cuttingedge of the bladefacing the front

of the tool.

1. To adjustthe cutting angle, first turn the tool upside down and loosen the hex screw that

secures the blade guide assembly located on the underside of the tool using the hex key

provided (Fig. 17).

2. Loosen the hex screw securing the base plate. Move the base plate slightlyforward and

tilt it to the required angle between 0° and 45° using the scale marked on the base

bracket.The base plate has indents at 0°, =L-45° for easy angle setting.

3. Slide the blade guide assembly until the blade guide restsagainst the back edge of the blade.

4. Re-tighten the hex screws.For accurate work, it is necessary to make a trial cut, measure

the work and reset the angle until the correct setting is achieved.

Fig.17

Z_ WARNING: To avoidaccidents,ALWAYSdisconnect the tool from the power source I

BEFORE making any adjustmentsor attaching accessories.

I Z_ WARNING: DO NOT letfamiliaritywithyoursaw makeyou careless.Rememberthat a

carelessfractionof a secondis sufficientto cause severeinjury.

,/_ WARNING:The useof attachmentsoraccessoriesthatarenotrecommendedcouldbedangerous.