Manual

THE EDGE GUIDE (Fig. 19)
This accessory (included) is
usedfor straightcutting:
1. Insert the bar of the edge guide through
the slotsinthe baseof the sabre
saw (See Fig.19) It can be insertedfrom
either side ofthebase withthe edge guide
facing down.
2. Screwtheedge guide locking knob
intothe threaded hole in thebaseto
tighten the edge guide bar in place.
3. Once theedge guideisattached, measurethe distancefrom the edge ofthe workpiecetothe
line-of-cut.
4. Set the edge guide to the same distance and then securelytightenthe edge guidein place
with the locking nut tightened down (see Fig. 19),
CIRCLE CUTTING (Fig. 20)
This requires usingthe CircleCutting/ StraightEdge Guide (9-27959) soldseparatelyat your
localSears Store.
1. BEFORE attachingthe edge guide, Fig. 20
draw a cimle and drilla holeinthe center
of thecircle(see Fig.20).
2. Drillor plungecut neartheedgeofthecircle.
3.Turn offsawand disconnectplugfrom
powersource.
4. Attachthe edge tosaw (the sameway
you attached the includededge guide)
with the edge guide facing up
5. Place the metalcenter point on the
edge into the hole in the centerof the circle.
In order for the edge guide to cut a circle,
the metal center point MUST BE in
alignment with the saw blade (see Fig. 20).
6. Measurethe distance from the selectedhote to theblade;this distanceis equalto the circle radius.
7. Insert saw plug into power source.
8. Hold saw firmly, squeeze the trigger switch and slowlypush the saw forward.
NOTE:To make a hole, cutfrom inside the circle;to make wheelsor discs,cutfrom the outside.
21