Manual

WALL-MOUNT CAPABLE (Fig,, 5)

The charger has a key-hole hanging feature

for convenient storage. Screws should

be installed so that the center distance is

3-5/32-in. Use appropriate wail fasteners to

accommodate the combined weight of the

charger and battery pack. (approximately

3.5 lbs_ combined)

CORD WRAP

The charger is equipped with a cord wrap

on the rear of the unit. Utilize this feature to

minimize workspace clutter and hazards.

Fig. 5

O {_ 3-5/32-in. -_ O

c::=®r-• 0c::

O O

_CAUTIION: When placing the battery pack in the tool, be sure the raised rib on the

battery pack aligns with the housing on the rear of the saw and latches into place properly.

Improper installation of the battery pack can cause damage to internal components.

_WARNgNG: Do not attempt to modify this saw or create accessories not

recommended for use with this saw. Any such alteration or modification is misuse

and could result in a hazardous condition leading to possible serious injury.

_WARNII_IG: Always remove the battery pack from the tool when assembling parts,

changing blade and making adjustments. Failure to obey this warning could cause

serious personal injury.

TO ATTACH BATTERY PACK (Fig 6)

[] Align the raised portion on the battery

pack with the grooves on the bottom of the

housing on the rear of the saw, then attach

the battery pack to the saw as shown

[] Make sure the latch on the battery pack

snaps into place and the battery pack

is secured to the saw before beginning

operation.

TO DETACH BATTERY PACK (Fig, 6)

[] Press the latch located on the front of the

battery pack to release battery pack,

[] Pull backward on the battery pack to

remove from the saw..

Fig. 6

SAW BLADES

The best of saw blades wilt not cut efficiently if they are not kept clean, sharp and properly set°

Using a dull blade will place a heavy load on the saw and increase the danger of kickback. Keep

extra blades on hand, so that sharp blades are always available

Gum and wood pitch hardened on the blades will slow the saw down. Use gum and pitch

remover, hot water or kerosene to remove these accumulations, DO NOT USE GASOLINE.