Manual

BLADEGUARD SYSTEM (Fig 7)
The lower blade guard attached to your saw
is there for your protection and safety, it
should never be altered for any reason,, If it
becomes damaged or begins to return slow
or sluggish, do not operate the saw until
the damage has been repaired or replaced.
Always leave blade guard in operating
position when using the saw
_DAHGI_R: When sawing through
workpiece, lower blade guard does
not cover blade on the underside of
workpiece. Since blade is exposed on
underside of workpiece, keep hands
and fingers away from cutting area. Any
part of your body coming in contact with
moving blade will result in serious injury.
Fig. 7
Lower blade guard is in up
position when making a cut
Blade exposed on
underside of workpiece
,_CAUT_ON: Never use saw when guard is not operating correctly. Check the guard
for correct operation before each use. The guard is operating correctly when it moves
freely and readily returns to the closed position. If you drop the saw, check the lower
blade guard and bumper for damage at all depth of cut settings before reuse.
_V#ARNItHG: When using the saw, always stay alert and exercise control. Do notremove the saw from the workpiece while the blade is moving.
KICKBACK (Fig_ 8-11)
Kickback occurs when the blade stalls rapidly and the saw is driven back towards you. Blade
stalling is caused by any action which pinches the blade in the wood,,
Fig_ B
/ J
Blade is SetToo Deep Correct Blade Depth
2O