Manual

_WAR_IIING: LASER LIGHT. LASER RADIATION° Avoid Direct Eye Exposure,

DO NOT stare into beam. Only turn laser beam on when the saw is on the workpiece.

The laser is factory installed and aligned. Class Ilia laser.

I NOTE: Make a trial cut on a piece of scrap material to ensure the laser is aligned properly. 1

USING THE LASER TRAC TM LASER GUIDE

(Fig,, I4-!5)

To operate the laser guide:

[] Remove battery pack from saw

[] Mark the line to be cut on the workpieceo

Adjust the depth and angle of the cut as

neede&

[] Install the battery pack.,

[] Slide the Laser!LED switch back to turn

laser on,

[] Start the saw,

Fig, t4 Laser/LED

switch

NOTE: Do not touch the blade to the

workpiece until the saw has reached

maximum speed.

[] Align laser beam with fine-of-cut and slowly

push the saw forward into the workpiece

[] Once the cut is complete, release the

trigger switch and allow the saw to come to

a complete stop

[] Always turn laser beam off when you have

finished cutting,

USING THE LED WORKLIGHT (Fig. I4 & '16)

The saw is equipped with a fixed-position

worklight for better visibility when cutting,,

To operate the LED worklight:

[] Slide the Laser/LED switch forward to turn

worklight on,

NOTE: The laser guide or worklight will

automatically shut off approximately

four to seven minutes after the switch

trigger is released,

_WARNIING; The worklight aids

in illuminating the cut-line. It is NOT

a substitute for adequate work area

lighting. Failure to obey this warning

could cause serious personal injury.

F_g. t¢

Field of illumination

3 4