Manual

0° BEVEL STOP
The saw has a 0° bevel stop that has been
factory adjusted to assure 0° angle of the saw
blade when making 90 ° cuts.,
TO CHECK 0° BEVEL STOP (Fig° 24)
[] Remove battery pack from the saw,
_WARN,NG= Always remove the battery
pack from the tool when assembling parts,
changing blade and making adjustments.
Failure to obey this warning could cause
serious personal injury.
m Place the saw in an upside down position
on a workbench,,
[] Using a carpenter's square, check the
squareness of the saw blade to the base of
the saw°
TO ADJUST 0° BEVEL STOP (Fig. 25)
[] Remove battery pack from the saw,,
[] Loosen the bevel adjustment knob.
[] Place the saw in an upside down position
on a workbench_
[] Using a 3/32-inch hex key, turn the 0° bevel
stop adjusting screw until it is square with
the saw blade,
_kWAR_ItlNG; Attempting to make
cuts without the bevel adjustment knob
securely tightened can result in serious
injury.
POCKET CUTTING (Fig 26)
,_WARMgNG: Always adjust bevel
setting to 0° before making a pocket cut.
Attempting a pocket cut at any other
setting can result in loss of control of the
saw, possibly causing serious injury.
1_ Remove battery pack from the saw_
[] Adjust the bevel setting to zero.
[] Set the blade to the correct blade depth setting,
[] Place battery pack in saw,
[] Swing the lower blade guard up using the
lower blade guard lever.
i
NOTE: Always raise the lower blade guard
up using the lower blade guard lever to
avoid serious injury.
Fig= 24
Carpenter's square
Blade
Base
Underside of saw base
|
I
28