Manual

LUBRICATION
All of the bearings in this tool are lubricated with a sufficient amount of high-grade lubricant for
the life of the tool under normal operating conditions+. Therefore, no further lubrication is required.
CHANGING THE BLADE (Fig,. 27)
_WARNgNG- A 7 114-in. blade is the maximum blade capacity of the saw. Use only
7 l14-in, blade when replacing worn or damaged blades. Never use a blade that is too
thick to allow the outer blade washer to engage with the flats on the spindle. Thicker
blades will prevent blade screw from securing blade on spindle, resulting in serious
personal injury.
[] Remove battery pack from the saw
[] Loosen depth of cut adjustment lever. Raise the saw to maximum height and tighten depth of
cut adjustment lever. This practice allows easier access to blade mounting_
[] Locate and remove the hex key from the storage area+
[] Depress spindle lock button and place hex key in the blade screw and move it back and forth
unfit you feel the spindle lock button depress further,. This action locks the blade in position so
the blade screw can be removed+ With the spindle lock button firmly depressed, turn the blade
screw clockwise to remove,.
[] Raise the lower blade guard using the blade guard lever and hold it in the raised position+
[] Remove the blade screw and the outer blade washer and the blade.
[] The remaining washer is the inner bushing washer that fits around the spindle shaft and does
not need to be removed+.
Place a drop
I_ of good-quality
machine oil
inner bushing
washer
Direction of
blade rotation
(teeth point up
at front)
\
\
Spindle Lock
Button
Outer
bEade washer
Blade screw
3O