Operating instructions
RightFax 8/15/2003 1:18 PAGE 5/11 RightFax
• Depress latch and slide magazine cover open (see
Figure 2).
F;o.I.O.o.a0=..
• Insert fasteners into magazine. Position fasteners at bottom
of magazine with head towards top of tool (see Figure 3).
Figure 3 - Load Magazine
• Slide magazine cover forward over magazine until latch
snaps Into place, locking magazine cover (see Figure 4),
Figure 4 - Close Magazine
NAILING OPERATION
Refer to Figures 5, 6, 7 & 8 (pages 4 and 5).
WARNING: Read and fonow all safety rules and operating
instructions in this manual and on warning label of too_ before
using this tool. Keep this manual with the tool.
WARNING: Do not use this tool wift_Jt safety warning
isbel. If label is ndssw,g, damaged or unreadable, contact
Seam to obtain a new label.
WARNING: Never operate tool unless contact trip is in con-
tact with wod_pisce. Do not operate toot without fasteners or
damage to tool may result. Never fire fasteners into the air
because fasteners may injure operator or others and damage
to tool may result.
• Pertorm "Safety Mechanism Check" as described in the
Maintenance sec_on (see page 6) prior to first use of tool
and on a daily basis thereafter.
• The tool is equipped with a rotating switch that can be set
to rapid-fire orstogle-fire mode (see Figure 5). When the
switch is set to single-fire mode, the tool will not drive a
second fastener until the trigger is fully released and
pulled again.
• When the switch is rotated to rapid-fire mode. the tool can
drive fasteners continuously. A fastener will be fired each
time the contact top is pressed against the workpmce, as
long as the _='kJgeris maintained in the pulisd position.
Figure 5 - Push and rotate swltoh to select
Operation Mode
SINGLE-FIRE OPERA1]ON;
• The air tool is equipped with a contact trip safety mecha-
nism that disables too# unless_sct lrip is pushed
against work. To drive a fastener hold body firmly and
press contact tnp on workpisce where fastener is to be
applied. Pull trigger to ddve fastener into workplace. To fire
a second fastener lilt the tool from the workpisce, release
the trigger and then repeat the above sequence.
RAPID-FIRE OPERATION:
• The toal can also be operatad by holding bigger
depressed and pushing contact trip against workplace. A
fastener will be driven each time the cordact trip is pushed
against the workplece. This opera_ng procedure provides
rapid-fire fastener ddving. Never operate tool unless con-
tact b'ip is in contact with workpisce.
4