Operating instructions

RightFax 811512003 I:18 PAGE 7111 RightFax

SAFETY MECHANISM CHECK

Inspect contact trip safety mechanism daily for proper opera-

tion Do not operate tool if mechanism is not operating

properly

With the red push-button switch in the rapid-fire mode, per-

form the fo_towing procedures to test safety mechanism:

• Leave trigger untouched while pushing contact trip Into

workpiece Tool must not fire.

• Pull trigger while contact trip Is dear of wolf and pointed

away from operator and o'_ers. Tool must not fire.

• Depress and hold trigger, push contact trip against work

where _stener is needed. The tool should drive only one

lastener each time the contact trip is pushed against

workpiece

If co.tact t_lp mechanism does not operate properly,

repair tool Immediately through Sear/Servloa Center.

Replace any damaged or missing parts. Usa the parts list to

order parts.

REBUILD KITS

Rebuild kits ere available as spare ports, (see page 9}. Tools

should be rebuilt ff tool falls to operate properly after e_fanded

use. See troubleshooting to determlse required replacement

parts

Disconnect tool from air supply before attempting repair

or adjustment.

NOTE: When replacing O-rings or cylinder, lubricate with

grease before assembly