Operator`s manual

LOADING
Refer to Figures 2, 3, 4 & 5.
WARNING: Disconnect toot from air supply. Do not toad tool
until you are ready to use it. Do not pull trigger or depress
contact trip while loading toot. Always load with nose of tool
pointing away from you and others. Always wear safety gog-
gles that comply with United States ANSI Z87.1.
NOTE: For best results, use Sears fasteners only.
Depress latch and slide magazine cover open (see Figure 2).
Figure 2 - Open Magazine
Load nails: Place nail strip so that the chisel points rest on
the bottom of the magazine (see Figure 3).
Figure 3 - Loading Nails
Loading staples: Position staples so that the staple strip
straddles and rests on the inner wall of the magazine (see
Figure 4).
Figure 4 - Loading Staples
Slide magazine cover forward over magazine until latch
snaps into place, locking magazine cover (see Figure 5).
Figure 5 - Close Magazine
NAILING AND STAPLING OPERATION
Refer to Figures 6, 7, 8 & 9 (pages 5 and 6).
WARNING: Read and follow all safety rules and operating
instructions in this manual and on warning label of tool before
using this tool. Keep this manual with the tool.
WARNING: Do not use this tool without safety warning
label. If label is missing, damaged or unreadable, contact
Sears to obtain a new label.
4