Operator`s manual

• Avoid accidental start-up Make sure that the switch
is in the OFF position before plugging in
• Do not force tool It will work most efficiently at the
rate for which it was designed
• Keep hands away from moving parts and cutting
surfaces.
• Never leave tool running unattended. Turn the power
off and do not leave tool until it comes to a complete
stop.
• Do not overreach. Keep proper footing and balance.
• Never stand on tool. Serious injury could occur if tool is
tipped or if blade is unintentionally contacted.
• Know your tool. Learn the tool's operation, applica-
tion and specific limitations.
• Use recommended accessories (refer to page 13).
Use of improper accessories may cause risk of
injury to persons.
• Handle workpiece correctly. Protect hands from pos-
sible injury.
• Turn machine off if it jams. Blade jams when it digs
too deeply into workpiece. (Motor force keeps it
stuck in the work.)
• Always keep drive, cutterhead and blade guards in
place and in proper operating condition.
• Feed work into blade or cutter against direction of
rotation.
CAUTION: Think safety! Safety is a combination of
operator common sense and alertness at all times
when tool is being used.
WARNING: Do not attempt to operate tool until it is
completely assembled according to the instructions.
Refer to Figure 1 below
Check for shipping damage If damage has occurred, a
claim must be filed with carrier Check for complete-
ness Immediately report missing or damaged parts
Call 1-800-266-9079 to obtain replacement parts
The jointer/planer is shipped complete in one carton
Additional parts which need to be fastened to joint-
er/planer should be located and accounted for before
assembling
A Jointer
B Fence Assembly
C Fence Bracket Assembly
D Push Blocks (2)
Hardware bag includes:
• M6 x 20mm Socket Pan Head Screws (4)
• 6mm Lock washer (8)
• Mounting Bracket (4)
• M6 x 12mm Socket Pan Head Screws (4)
• Magnet
• Switch Key
• 3mm Hex Wrench
• 4mm Hex Wrench
A
C
Figure 1 - Unpacking
Refer to Figures 2 and 3.
D
ATTACH FENCE ASSEMBLY
Attach fence bracket assemblies to fence using four
M6 x 20 screws and lock washers. There is a right
side and a left side bracket assembly. See Figure 2
for correct installation. Do not completely tighten
screws
Attach fence assembly to jointer bed using four M6 x
12 screws and lock washers (B) Pull blade guard
back so that fence can be properly fitted to jointer
(see Figure 3)
Completely tighten all screws Secure fence in posi-
tion with locking handles (C)See Figure 2
Figure 2 - Attach Fence Assembly
Figure 3 - Swing Blade Guard Back to Install Fence
3