Operator's Manual tP BUFFER Model No. 351.226250 CAUTION: Read and follow • • • • • • all Safety Rules and Operating Instructions before First Use of this Product. Keep this Manual with Tool. Sears, Roebuck and Co., Hoffman www.sears.com/craftsman 23761.00 Draft (04/29/05) Estates, IL 60179 U.S.A.
° Work area should be properly lighted. Warranty ......................................... 2 Safety Rules ...................................... 2 Assembly ........................................ Installation ...................................... • Extension cords should have a grounding prong and the three wires of the extension cord should be of the correct gauge. 3 3-4 Operation ........................................ Maintenance ..................................... 4 4 Troubleshooting ....
° Refer to Figure 3, page 6. CAUTION: Do not attempt assembly if parts are missing. Use this manual to order replacement parts. Buffer comes completely assembled with hex nuts, wheel flanges and spacers (Key. Nos. 1,2, 3 and 11) packed separately. One spiral sewn wheel and one soft wheel are included. IMPORTANT: Do not attempt assembly if parts are missing. Use this manual to order replacement parts.
(A3-prong to2-prong grounding adapter is notpermitted in Canada.) Wherepermitted, therigidgreentaborterminal on thesideoftheadapter mustbesecurely connected toa permanent electrical ground suchasa properly grounded waterpipe,a properly grounded outletboxora properly grounded wiresystem. • Manycoverplatescrews, waterpipesandoutletboxes are notproperly grounded. Toensure properground, grounding means mustbetestedbya qualified electrician.
SYMPTOM POSSIBLE CAUSE(S) CORRECTIVE ACTION Buffer won't start 1. Blown line fuse or tripped circuit breaker 1. If fuse is blown, replace with fuse of proper size. If breaker tripped, reset it 2. Low line voltage 3. Defective switch 4. Defective, blown capacitor Excessive vibration Motor overheating 2. Check power supply for voltage and correct as needed 3. Replace switch 4. Replace capacitor 1. Improper mounting of buffing wheel on buffer 1. Remount 2. Buffing wheels not balanced 2.
Models 351.
KEY NO. 1 PART NO. 00064.00 DESCRIPTION 2 23754.00 Wheel Flange 4 3 04647.00 STD840508 Spacer 5-0.8mm Hex Nut* 2 4 5 STD551210 #10 Serrated Washer* 3 '/2"-12 Hex Nut (LH Thread) QTY. 1 4 6 16704.01 Endshield 2 7 STD315225 2 8 16669.00 6202ZZ Bearing* Motor Fan 1 9 23755.00 Armature 1 lO 23756.00 1 11 00548.00 Stator With Housing '/2"-12 Hex Nut 12 01066.00 Grommet 1 13 00067.00 Line Cord 1 14 04055.00 Strain Relief 1 15 23757.00 Base 1 16 08066.
PULIDORA de 6" • Use gafas de seguridad que cumplan con la norma ANSI Z87.1 de los Estados Unidos. Los anteojos comunes tienen lentes que s61o son resistentes al impacto. NO son gafas de seguridad. Modelo No. 351 •226250 • Use una mascara sial • para la cara o una mascara utilizar la herramienta se produce Este alerta y piense claramente. contra el polvo, mucho polvo.
• Mantenga las manos alejadas las superficies de las partes movibles y de Nunca deje desatendida una herramienta en funcionamiento. Desconectela y no abandone el lugar hasta que se haya detenido por completo. • No trate de alcanzar equilibrado. • Nunca se pare sobre la herramienta. Se pueden producir lesiones graves si la herramienta se vuelca o hace contacto con la correa o el disco.
• Revise peri6dicamente loscordones delaherramienta ysi estb.n daBados, Ilevelos a uncentro deservicio autorizado paraquelosreparen. • Elconductor verde (overde y amarillo) delcord6n eselcable deconexi6n atierra.Siesnecesario reparar oreemplazar el cord6n electrico oelenchufe, noconecte elcable verde (o verde y amarillo) aunterminal cargado.
SINTOMA CAUSA(S) La pulidora no arranca 1. Fusible de linea quemado de circuito disparado MEDIDA POSIBLE(S) o interruptor CORRECTIVA 1. Si el fusible est,_ quemado, reemplacelo de capacidad adecuada. Si el interruptor reponga 2. Voltaje de Ifnea bajo 3. Interruptor Vibraci6n El motor excesiva se recalienta quemado, 1. Rueda pulidora el interruptor 2. Verifique el voltaje del suministro necesario defectuoso 4. Capacitor defectuoso mal instalada en la pulidora 3.
® Registered Trademark / TM Trademark / Sh4 Service Mark of Sears, Roebuck and Co. ® Marca Registrada / TM Marca de F_brica / SM Marea de Servicio de Sears, Roebuck MC Marque de commerce / MD Marque d_pos_e de Sears, Roebuck and Co. and Co. © Sears, Roebuck and Co.
