Manual

• ,Secure bracketsinto tool restbases using lockinghandles.
INSTALL LEVER, HANDLES AND FINE
ADJUSTMENT SCREW
Refer to Figure 6.
• Insert bushingsinto lever. Slide 8 x 20mm sockethead bolts
through bushings.Thread boltsintocarriage and block.
• Thread the four handles with knob intothe hub.
Hex Nut
Fine Adj
Screw
Carriage
Leverwitch i
Grip
L
,-<_Socket Head Bolt
Figure6 - Install Leverand Handles
• Thread fine adjustment screw with hex nut into block.
INSTALL CUTTING TOOL AND SAFETY SHIELD
Refer to Figure 7.
Insert cuttingtoolintotoolholder and use 8 x 10mm set
screwto secure in position.Cuttingtool shouldextendout
approximately1W' from holder.
Slide safety shieldonto tool holder.Secure in positionwith
pan head screw.
Check height of cuttingtool Cuffingtoot shouldbe approxi-
mately ',_"above the spindlecentedine. Insert canters into
headstock and tailstockspindlesand check tool at each
spindle.If necessary,adjust heightby removingspacers
beneath brackets.
Pan Head Screw--->T
Safety i
ToSoo:tHSo_rd';_'-_ hield "_k _
'_r'_"Cutting Tool
Figure 7 - InstallCuttingTooland SafetyShield
INSTALL GUIDE PIN AND FOLLOWER ASSEMBLY
Refer to Figure 8.
Remove protectivepaper from cover.
Insert guide pin intoslot of yoke. Secure in positionwith
washer and hex nut.
• Slide follower assembly onto guide pin.Secure in position
withsocket head bolt.
C_ _ Scre_
Yoke
"_'N3uide Pin
FollowerAssembly _,,_
.L "_-Washer
Socket Head Bolt _ _'_r-_
",_ "_,_-- Hex Nut
Figure 8 - Install GuidePin and FollowerAssembly
INSTALL PATTERN SUPPORT
Refer to Figure 9.
• Thread pattern boltand hex nut into pattern support.
Insert8 x 60mm socket head bolt and fiatwasher intoslotof
pattern support and bracket and secure in position with
bracket nut.
Bracket Nut _Bracket
Support
Figure 9 - Install Pattern Support
ATTACH CARRIAGE SUPPORT TO CARRIAGE
(MODEL 24951)
Refer to Figure 10.
• Loosen set screwand position carriagesupport against
carriage.
• Secure carriage supportto carriage with8 x 25mm socket
head boltsand fiat washers.
• Secure carriage supportto guide with set screw.
Washer Socket Head Bolt
Carriage Support_ _,_
Bed
Figure 10 - Attach Carriage Support to Carriage (Model 24951)
5