Owner`s manual

USING THE POWER SHARP SYSTEM [MODEL .3536901
12
Model .353690 is equipped with a Power Sharp
System that will perform approximately 80% of
the sharpening necessary for the saw chain. The
Power Sharp System utilizes a built-in grinding
stone to sharpen the cutter top plates,and set
depth gauges. As the built-in sharpener is used,
the cutter side plates gradually will be altered,
About every 3rd to 5th time the Power Sharp
System is used, hand filing is required to correct
the c_btter side plates.
• Sharpen the saw chain when:
--wood chips become small and powdery.
Wood chips made by the chain should be
about the size of the teeth of the chain.
--saw_e_uts to one side.
--saw has to be forced through the cut.
......A: AUTOMATICSH ARPENING .............................
Replace the sharpening stone when a new
Power Sharp chain is installed. See instruc-
tions, page 13.
Remove the sharpening stone if a standard or
conventional chain is substituted for the
Power Sharp chain. See instructions for
removing the sharpening Stone and Carrier
Assembly, page 13. Use replacement chain
for Model 358..353670 (2_31t6")_ StoCk, No.
36-3629. Follow conventional chain sharpen-
ing instructions on page 17.
ICAUTiON:IAIways wear gloves when handling
the chain. The chaincan cut you even though
it is too dull to cut wood.
1. Stop the engine.
2. Place saw on a solid, flat surface; and ensure
that the chain will not contact any object.
3. Adjust the chain with proper tension. Refer to
Chain Tension, page 7.
4. Start engine and operate at ha!f throttle.
5. Press the Power Sharp Knob down until you
feel the sharpening stone lightly contacting
the chain. Figure 23.
6. Maintain constant, tight pressure on the
Power Sharp Knob while 'moving the knob
side to side for 5 seconds.
7. Release Power Sharp knob and stop engine.
8. Inspect chain cutters.
NOTE: A properly sharpened cutter will sflow
grinding marks across its entire width. Figure
24.
B._ _HAND FILING:
SharpemiSaw_chain side plates by hand after
every3rd toSth time the Power Sharp system is
used.
1. Stop the engine.
2. Adjust the chain for proper tension, page 7.
3. S0pport the square rod on the file holder (with
5t32" round file) on cutter top plate: Figure 25.
INSTRUCTION
DECAL POWER SHARP KNOB
Figure 23
TOP VIEW OF CUTTER
INSPECT CUTTERS FOR GRINDING MARKS
Figure 24
NOTE: Work at the_midpoint of the bar, mov-
ing the chain forward with a screwdriver as
each cutter is filed.
4. Hold the file holder level with the 22° guide
mark parallelto guidebar. Figure 26.
SUPPORT THE SQUARE ROD
ON FILE;HOLDER FLAT
ON TOP OF cu'n'ER -_ _OUND E-ILE
• _ _.K-_A'_"_.-DEPTH
ToP GUAGE
PLATE
SIDE _o
PLATE
Figure 25
22=;
= i ,,Hi ._l
Figure 26