Owner`s manual

1. Drainfueltank.
2. Removethe two screwson the side of the
fan housing.Figure49.
3. Removethe largescrewat the rearof the
control handleandthesmall screwdirectly
belowit. Figure50,
4. Pullthegaslinefromthefitting goingin-the
sawhandle.
5. Separatethefan housingfromthe unit.
6. If the starterropeis not broken,releasethe
spring_ensionbypullingabout10inchesof
rope fromthe pulleyandcatch the rope in
the notch as shown. Figure 51.
NOTE: The tension on the starter spring will
be released if the rope has broken.
7. Turn the pulley counterclockwise until the
•spring tension is released.
8. Remove the pulley screw in the center of the
pulley. Figure 52.
9. Lift the pulley_,arefully while gently twisting
it counterclockwise _1_ .
10, Remo_e the old rope.
11. Move away from the fuel tank and burn the
end_efJthe rope tO be installed.
12. Pull the burnt end through a rag while the
rope is still hot to obtain a smooth end.
t3. Feed the rope through the housing and
through the round starter hole. Figure 52.
14. Put the rope into the pulley groove and up
through the hole.
15. Tie a knot in the end of the rope and pull it
tightly against the pulley.
16. Rewind all the rope onto the pulley, turning
counterclockwise 4[-,,_
17. Set the pulley into the housing; push it down
and engage the spring.
18. Replace and tighten the pulley screw.
19. Pull out 10 inches of rope and set the rope in
the notch in the pulley. Figure 53.
20. Turn the pulley 2 complete turns clockwise
winding up the spring.
21. Hold the pulley and pull the starter rope to
'the full extent of length and let the rope re-
wind _!owly.
. :_22..Replace_the fueI.Jine in_theostoLin the fan
housing, Be certain fuel line is not pinched.
23. Rel_aC6: fan housing.
REMOVE
FAN HOUSING
SCREWS
REMOVE CONTROL
....
Figure 50
TURN PULLEY
-_)_.,,_U-•• COUNTERCLOCKWISE
NTIL TENSION IS RELEASED
= =l= , = i i
Figure 52
NOTCH
Figure 53
Figure 49
20