Owner`s manual

PREPARING YOUR SAW FOR USE
A. GETTING READY
1. READ YOUR OWNER'S MANUAL CARE-
FULLY.
Your Owner's Manual has been developed to
help you prepare your saw for use and, to
understand its safe operation. It is important
that you read your manual completely to
become familiar with the unit before you
begin assembly,
2. HAVE THE FOLLOWING AVAILABLE:
a. Protective gloves
b. Approved, marked fuel container _...
c. One gallon leaded or unleaded, regular
gasoline
d. Bar, and Chain Lubricant (see page 9).
e. Bar Adjusting Tool provided with your_unit.
One end of the tool serves as a wrench;
the other can be used as a screwdriver.
No other too! is necessary for assembly.
Su ATTACHING THE HANDGUARD
The. ;Ha,ndguardis a, protective device designed
to help°prevent your hand from coming in con-
tact with the cutting chain should your hand slip
off the handlebar. It will not eliminate the
possibilityof injury from kickback or loss of con-
trol of the saw.
HANDGUARD CAP
.... ;WARNING! ' --,. t
Do not usethe saw.without the handguar_!':in
place.
• Lift and carry the chain sawby the handlebar
HANDLE-_
U PiN
illll
Figure I
C, Alr_,ACHiNG_THE BAR,AND CHAIN,
or rear handle, not by the handguard:
• Keep the handguard securely fastened at all
times. Check the handguard screws each
time the saw is used ......
To install:
1. Align the Handguard and Handguard Cap
around the handlebar as shown in Figure 1.
2. Fit the mounting pinch the Handguard into
the hole in the handlebar. Figure 1, (insert).
3. Insert the 3 mounting screws into the3 holes
on the Handguard Cap.
4. Turn each screw a little at a time clockwise,
until the Handguard Cap and Handguard
meet and there is no 'gap between the two
parts.
•ICAu]:ION-'twear protectivegloves_wSemhan.
dling or operating your saw..The chain is; sharp
and can cut you even when it is not moving!
• Your_saw is equipped with'a Lo Kick Guide
Barand.a Guard Link Chain designed to help
reduce kickback,
• Always.use .the Lo Kick-Guide Bar and Guard
Link Chain designed for your particular chain
saw, when replacing lhese pads,
TURN
ADJUSTING
SCREW
COUNTE RCLOCKW
Figure 2
1. MODEL .353660 (2.3/i4")
a. Remove the following parts as sho:v_n in
Figure 2, using the Bar Adjusting Tool pro-
vided with the unit.
1.) Bar Clamp Nut.
2.) Rear Bar Clamp Screw.
3.) Bar Clamp.
b. Turn the Adjusting Screw counterclock-
wise _ to move the Adjusting
Pin almost as far as it will go to the rear.
Figure 2.
5