Owner`s manual
CLUTCH '
Figure 3
CLUTCH
Figure 4 :
Figure 5
•CLAMP
SCREW
ADJUSTING LEVER
_BAR CLAMP
R CLAMP NUT
\
Figure 6
CLUTCH
Figure 7
c. Hold chain with cutters facing as shown in
Figure 3.
d. Place chain over and behind the clutch
drum, onto the sprocket. Figure 3.
e. Place the Guide Bar on the saw by fitting
the long slot in the Guide Bar over the Bar
Stud. Figure 4.
NOTE: Be sure the Guide Bar is positioned
with the adjusting pin hole below the large
slot.
f. Hold the Guide Bar at a 45 degree angle to
the saw and fi[the chain into the GuideBar
grooves -- first, the top groove and then,
the bottom groove.
g. Lower the Guide Bar; fit the adjusting pin
into the small hole below the large slot; fit
the large slot on themounts on either side
of the Bar Stud. Figure 5.
• h/NOTE: Check tO be sure fuel line is _in
place. Figure 5.
L Hold the Guide Bar against the saw frame
and install the Bar Clamp.
j. Secure the Bar Clamp with the Bar Clamp
Nut, finger tight only..
NOTE: The Bar Ctamp Nut must be slightly
loose for the chain to be tensioned properly.
Securely tighten Bar Clamp Nut after
chain is tensioned.
k. Replace the Rear Bar Clamp Screw and,
tighten.
I: Follow "ChainTension" instructionsl page 7.
2. MODELS .353670 (2.3116") and .353690
(2.3116" PS)
,: a ._Remove :the ;foilowing :parts. as shown!in
Figure 6, using the.Ba[._djusting Tool pro-
.vided with the unit.
1.) Bar Clamp Nut.
2.) Adjusting Lever.
3.) Rear Bar Clamp Screw.
4.) Bar Clamp.
b. Hold chain with cutters facing as shown in
Figure 7.
c. Place chain over and behind the clutch
drum, onto the sprocket. Figure 7.
NOTE: For Model 353690 (2.3!16") Power
Sharp, fit the chain into the sprocket
g rooves.
d. Place the Guide Bar on the saw by fitting
the long slot in the Guide Bar over the Bar
Stud, Figure 8.
NOTE: Be sure the Guide Bar is positioned
with the pin below the large slot.