Owner`s manual

F!
Gm
• o' InTfreezing weather oil will thicken, making it
._°-_h_b_e:ssaryto thin barand chain oil with a
small amount of Diesel Fuel #1 or Kerosene.
Bar and chain oit must be free flowing for the
oil system to pump enough oil for adequate
lubrication.
1__E THE FOLLOWING:
30°F or above--Lubricant--undiluted.
30°F- 0°F --95% Lubricant to
, ,_;.!_'_,:_ 5% Diesel Fuel #1
or Kerosene.
Below 0°F --90% Lubricant to
10% Diesel Fuel #1
or Kerosene.
2. HOWTO FILL THE OIL TANK
a. Turn-saw on its side with oil cap up. Figure
14.
b. Loosen cap slowly; wait for pressure,in the
tank to be released before removing the
: cap.
c. Fill the oil tank,
d. Replace the oil cap securely,
BAR AND CHAIN OIL
• The guide bar and cutting chain require con-
stant lubrication in order to remain in
operating condition, Lubrication is provided
by the automatic oiler system when the oil
tank is kept filled.
--Lack of oil will quickly ruin the bar and
chain,
--Too little oil will cause overheating shown
,by smoke coming from the chain andJor
,discoloration of the guide bar rails.
e Use SEARS Bar and Chain Lubricant #36554
or clean SAE 3OW oil,
3. IMPORTANT POINTS
a. Fill the oil tank each time you refill the fuel
tank to ensure there will be sufficient oil for
the chain whenever you start and Fun the
saw.
OIL •
CAP
b, it is normal for a Small amount of oil;to ap-
pear under the saw after the engine, stops
due to oil draining from the bar and _hain.
Figure 14
OPTIONAL MUFFLER, HEAT
SHIELD:ASSEMBLY
•The following instructions have been included
to help you install the optional Muffler Heat
Shield ,Kit,_Repair Part No. 69037. This kit will
REMOVE STANDARD
MUFFLER
pf.o_(_, you_ saw with a_temperatureolimiting
•muffle/" which may be re:quired by law in some
states;,See State and Local Ordinances, page 4
for_further information.
1. Remove the screw located in the center of the
-muffler body. Figure 15.
2. Rem_o_e the muffler cover from the muffler
b_dy'and discard.
NOTE: Do not remove other muffler parts. If
.other parts are removed, see muffler as*
sembly in Figure 46, page 19.
3. Install the temperature limiting muffler body.
Figure 16.
4. Replace screw and tighten securely.
JCAUTION:i Do not use an air wrench to tighten
the screw as parts can become overtightened
and damage can occur,
INSTALL HEAT
sH i E LD COVE R
F{gure 15
Figure 16
i i
9