Instruction manual

TROUBLESHOOTING TABLE
WARNING: Always stop unit and disconnect from tile power source before
performing all of the recommended remedies below except remedies that re-
quire unit to be operating.
TROUBLE CAUSE REMEDY
Trimmer head 1. Crowdh_g line against 1. Allow tip of line to do the cutth_g.
stops under a material being cut.
load or does not 2. Electrical failure. 2. Contact Sears Service (see back
turn when switch cover).
is pressed. 3. Thrown circuit breaker. 3. Check breaker box.
4. Debris stopping head. 4. Remove debris.
Line breaks 1. Une improperly routed 1. Check Ih_e routing.
while cutting, in head.
2. Incorrect line size 2. Use only 0.080 inch (2 mm) dia. line.
3. Dirt build-up on unit. 3. Clean unit.
Line welds onto 1. Line size is incorrect. 1. Use only 0.080 inch (2 mm) dia. line.
cutting head. 2. Crowding line against 2. Allow tip of line to do the cutting.
material being cut.
Line usage is 1. Line improperly routed 1. Check Ih_e routing.
excessive, in head.
2. Line size is incorrect. 2. Use onIy 0.080 inch (2 mm) dia. Iine.
3. Crowding line against 3. Allow tip of line to do the cutting.
material being cut.
4. Cutting head worn or 4. Contact Sears Service (see back
damaged, cover).
10