Instruction manual

SWEEPING
The fanning action of the rotating line
can be used for a quick and easy
clean up. Keep the line parallel to and
above the surfaces being swept and
move the tool from side to side.
Sweeping
CUSTOMER RESPONSIBILITIES
WARNING: Disconnect power source before performing maintenance.
CARE & MAINTENANCE TASK
Check for loose fasteners and parts
Check for damaged or worn parts
Inspect and clean unit and labels
WHEN TO PERFORM
Before each use
Before each use
After each use
GENERAL RECOMMEN DATIONS
The warranty on this unit does not
cover items that have been subjected
to operator abuse or negligence. To
receive full value from the warranty,
the operator must maintain unit as
instructed in this manual. Various ad-
justments will need to be made peri-
odically to properly maintain your unit.
BEFORE EACH USE
CHECK FOR LOOSE
FASTENERS AND PARTS
• Housing Screws
• Assist Handle
• Debris Shield
CHECK FOR DAMAGED OR
WORN PARTS
Contact a Sears Service Center for re-
placement of damaged or worn parts.
• Trigger Switch - Ensure switch func-
tions properly by pressing and re-
leasing the trigger switch. Make sure
motor stops.
• Debris Shield - Discontinue use of
unit if debris shield is damaged.
AFTER EACH USE
INSPECT AND CLEAN UNIT AND
LABELS
• After each use, inspect complete
unit for loose or damaged parts.
Clean the unit using a damp cloth
with a mild detergent.
• Wipe off unit with a clean dry cloth.
REPLACING THE LINE
• Always use Craftsman replacement
line.
Only use the line size specified and de-
signed for this unit for cutting grass and
small weeds.
NOTE: Before inserting new line into
the holes in the cutting head, locate
the three hole pattern. Follow direc-
tions as shown on the line glide plate.
1. Remove the old line from the cut-
ting head.
2. Clean entire surface of cutting head=
3. Insert both ends of your line
through the proper holes in the
side of the cutting head=