Instruction manual

Positioning
Tunnel
Line glide plate
4. Pull the line and make sure the
line is against the hub and ex-
tended full through the positioning
tunnels.
Line against the hub
Positioning
Tunnel
5. Correctly installed line will be the
same length on both ends.
CAUTION: If line is installed incor-
rectly, the cutting head will not function
properly and damage to the unit may
occur,
NOTE: Line glide plate must be
installed in cutting head before insert-
ing new line. To reinstall line glide
plate (if needed), align arrow with cen-
ter hole of three hole pattern on side
of cutting head as shown.
Center hole of three hole pattern
Line glide Arrow
Cutting head
USER REPLACEABLE SERVICE PARTS
REPLACEMENT PART
Container of Replacement Line
Assist Handle
Bolt Carriage, 1/4-20
Wing Nut
Shield Assembly
Edge Guide
PART NUMBER
71-85907
530403805
530403886
530016152
530404393
530403845
A
WARNING: Perform the following
steps after each use.
• Stop the unit and disconnect the
power source when not in use.
• Carry the unit with motor stopped.
• Store the unit so the line limiter
blade cannot cause injury.
• Store unit and extension cord in-
doors in a high, dry place out of the
reach of children. Store unit un-
plugged.
• Store unit with all guards in place.
Position unit so that any sharp ob-
ject cannot accidentally cause injury.