Operator`s manual

ASSEMBLY

Place the steering wheel cap over the center of the steering wheel 3.

and push downward until it “clicks” into place.

Attaching The Seat

NOTE:Forshippingreasons,theseatiseitherfastenedtothetractor

seat’s pivot bracket with a plastic tie, or mounted backward to the pivot

bracket. In either case, free the seat from its shipping position being

careful not to bend or kink the wiring harness and follow the instruc-

tions below to attach it.

Remove the two hex screws and nuts from the seat pivot bracket.1.

Align the front holes of the seat mounting bracket with the holes in 2.

the seat pivot bracket on your tractor and secure with previously

removedhexscrewsandnuts.SeeAinFigure4.

Plug the wiring harness into the seat safety switch in the bottom of 3.

theseat,asshowninBofFigure4.

NOTE:Thetractorwillnotoperatewiththewiringharness

disconnected.

Adjusting the Seat

Toadjustthepositionoftheseat,pullupandholdtheseatadjustment

lever. Slide the seat forward or rearward to the desired position; then

releasetheadjustmentlever.Makesureseatislockedintopositionin

a seat-stop before operating the tractor. See Figure 5.

WARNING

Before operating the tractor, make sure the seat is engaged in a

seat-stop. Engage the parking brake. Stand behind the machine and

pull back on seat until it clicks into place.

Tire Pressure

WARNING

Maximum tire pressure under any circumstances is 30 psi. Equal

tirepressureshouldbemaintainedatalltimes.Neverexceedthe

maximum inflation pressure shown on the sidewall of the tire.

The recommended operating tire pressure is:

Approximately 10 psi for the rear tires

Approximately14psiforthefronttires

IMPORTANT: Refer to the tire sidewall for exact tire manufacturer’s

recommended or maximum psi. Do not overinflate. Uneven tire pres-

sure could cause the cutting deck to mow unevenly.

Figure 5

Figure4

Figure 3