Operator`s manual

26
SERVICE AND MAINTENANCE
IMPORTANT: The V-belt found on your tractor is specially designed
to engage and disengage safely. A substitute (non-OEM) V-belt can
be dangerous by not disengaging completely. For a proper working
machine, use identical equipment belts as listed in the parts pages of
this Operator’s Manual.
To change or replace the deck belt on your tractor, proceed as follows:
Remove the deck as instructed earlier in this section.1.
Remove the belt covers from the spindle pulleys by removing the 2.
hex screws that fasten the covers to the deck. See Fig. 23.
It may also be necessary to loosen the hex nut on the left deck 3.
idler pulley to get the belt off the pulley and around the belt guard.
Carefully remove the deck belt from around the two spindle 4.
pulleys and the two deck idler pulleys. See Fig. 23.
To place the new belt, begin by routing the belt around the two 5.
outer spindle pulleys as shown in Fig. 23.
Then route the belt around the two deck idler pulleys as shown in 6.
Fig. 23.
Retighten the belt keeper rod loosened earlier.7.
Remount the belt guards removed earlier.8.
Re-install the deck, making sure the belt remains routed around 9.
the pulleys as instructed. The complete belt routing is shown in
Fig. 23.
Pull the right side of the belt, and place the narrow V side of the 10.
belt into the PTO pulley.
While holding the belt and pulley together, rotate the pulley to the 11.
left. Continue holding and rotating the pulley and belt until the belt
is fully rolled into the PTO pulley.
PARKING BRAKE ADJUSTMENT
WARNING
Neverattempttoadjustthebrakeswhiletheengineisrunning.Always
disengage PTO (Blade Engage Lever), move shift lever into neutral
position, stop engine and remove key to prevent unintended starting.
If the tractor does not come to a complete stop when the clutch-brake
pedal is completely depressed, or if the tractor’s rear wheels can roll
withtheparkingbrakeapplied,thebrakeisinneedofadjustment.
Contact the nearest Parts & Repair Service Center to have your
brakes serviced.
To locate the nearest Parts & Repair Service Center or to schedule
service, contact 1-800-4-MY-HOME®.
CHANGING THE TRANSMISSION DRIVE
BELT
NOTE: Several components must be removed and special tools (i.e.
air/impact wrench) in order to change the tractor’s drive belt. Contact
the nearest Parts & Repair Service Center to have your transmis-
sion drive belt serviced.
To locate the nearest Parts & Repair Service Center or to schedule
service, contact 1-800-4-MY-HOME®.
Figure 23
Hex Washer Screws
Belt Cover
Deck Idler Pulley
Spindle Pulley
This portion of the
belt routes around
the PTO Pulley
Belt Guard