Operator`s manual

3. Remove old spool.
4. Clean entire surface of hub and
spool.
5. Replace with a pre-wound spool
or cut two lengths of 13 feet (4 me-
ters) of 0.085" (1.85 mm) diameter
Craftsman brand line. Use of
heavier lines could overioad and
damage unit.
Ai_WARNING: Never use wire,
rope, string, etc., which can break off
and become a dangerous missile.
6. Insert one end of the line about 1/2
inch (I cm) into one of the small
holes in the upper section of the
inside of the spool.
9, Repeat on the lower section of the
spool.
Notches
lO.Ptace spool into hub with cut out
area of spool in line with eyelets
(see illustration).
\
Cut out
area of spool
7. Wind the line evenly and tightly
onto the spool. Wind in the direc-
tion of the arrow found on the
spool.
8. Push the line into the notch, leav-
ing 3 to 5 inches (7 - 12 cm) un-
wound.
11. Remove one line from notch and
feed line through eyelet. Repeat for
second line.
12. Reinstall the spool cap.
USER REPLACEABLE SERVICE PARTS
REPLACEMENT PART
Spool with 0.065" Trimmer Line
Spool Cap
Assist Handle
Wheel
PART NUMBER
71-85935
545124417
545124404
545124405
_WARNING: Perform the follow-
ing steps after each use.
• Stop the unit and disconnect the
power source when not in use.
• Carry the unit with motor stopped.
• Store unit with all guards in place.
Position unit so that any sharp ob-
ject cannot accidentally cause injury.
• Store unit and extension cord in-
doors in a high, dry place out of the
reach of children. Store unit un-
plugged.
EXTENSION CORD STORAGE
The extension cord can be stored on
the unit using the cord brackets as
shown.
14