Operator`s manual

2. Pushthetubeintothemotorhous-
inguntilitsnapsintoplace.
MotorHousing _'_._
3. Try to remove tube from switch han-
dle and motor housing. If the tube
remains in place, it is propedy
snapped into place. If the tube wilt
not remain in place, repeat steps 1
and 2. Push until the tube snaps into
place.
ATTACHING THE SHIELD
_WARNING: The shield must be
properly installed. The shield provides
partial protection from the risk of
thrown objects to the operator and
others. Your unit is equipped with a
line limiter pin, which cuts excess line
to the proper length while running.
NOTE: If shield is not properly
installed, damage to unit (including mo-
tor failure) will result,
1. Place the shield onto the motor
housing. Ensure the cutting head re-
mains free to rotate and the line is
not caught between the shield and
the motor housing (see illustration).
Motor Housing
Line Limiter
_ _hield
2. Align the installation arrow on the
shield with the installation arrow on
the motor housing as shown.
I_stallatiOnrrows
3. Twist the shield as illustrated until it
snaps securely into place. Make
sure the shield is assembled to the
unit as shown in the illustration be-
low and in the KNOW YOUR TRIM-
MER section of this manual.
WHEEL ASSEMBLY
1. Fit the two halves of the wheel to-
gether (see illustration).
Wheel
2, Attach the wheel to the trimmer.
Make sure the wheel is fitted into
the groove on the motor housing.
Motor
Housing
\