Operator`s manual

3
Ifthe starter rope is not broken, release the spring's
tension by pulling about 10inches of rope from the
pulley and catching the rope in the notch as shown
Figure 17 If the rope is broken, remove the broken
piece.
NOTE: The tension on the starter spring will be
released ifthe rope isbroken
4_ Remove screw and pulley very carefully, Figure 17
The recoil spring which lies beneath the pulley
must stay in the housing, flat against the bot-
tom. If the spring is disturbed, it will require con-
siderable time and effort to reinstall. Twist the
pulleygentlycounterclockwise _ asyoupull
up to release the spring
5 Move away from the fueltank and melttheend ofthe
rope to go into the pulley`
6 Allow the melted end to drip once; then while the
rope is still hot, pull the melted end through a rag to
obtain a smooth, pointed end
7 Insert rope through the rope exit hole in the fan
housing
8 Snake rope inside the pulley, then through topside
pulley hole by pushing the rope from the underside
holewith a small round object such as a Phillips
screwdriver. See Insert, Figure 18
9 Wrap rope counterclockwise _ around
pulley ratchet and tuck loose end back under rope
leaving a 3/8 to 1/4 inch tail Figure 18 Pull tightly
l& Wind all but about 10 inches of the rope counter
clockwise _ around pulley
11_ Replace pulley inthe housing Be sure the pulley is
all the way down and the spring is secured
12. Replace and tighten pulley screw Figure 17.
13 Hold the 10 inch slack in the rope and catch rope
in pulley notch. Figure 19
14 Hold the rope taut and make 2 complete turns
of the pulley counterclockwise _ to place
tension on the pulley Hold the pulley to retain
tension
I5. Align pulley notch with rope exit hole, pull starter
handle to the full extent of the rope and allow the
rope to slowly wind around the pulley
16 Reinstall the fan housing to the shroud.
;HET
Figure 17
SCREWDRIVER ._" / /
/
__ Figure 18
\
NOTCH
Figure 19
D, STORAGE
1 Clean the unit before storing. Pay particular atten-
tion to the air intake area,keeping itfreeof debris Use
a mild detergent and sponge to clean the plastic
surfaces
2 Do not store the unit or fuel in aclosed area where
fuel vapors can reach sparks or an open flame from
hot water heaters, furnaces, etc.
3. Store in a dry area out of reach of childrenr
A©©A$$@RBA$
VACUUM ATTACHMENT K_T ..................
2-CYCLE ENG_IRE OHL .......................
SPARK PLUG ...........................
SHOULDER STRAP I_BT (for Engine) ............
mmwwmwmlmmwm=_lm
====B=l=mm.mm#_
mmmm_m=#==m=_#=
............ 71-79991
....... 7%36555
illll.......
............ 7t-85783
13