Operator's Manual CRRFTSMRN 1.4 cu. in./24cc 2-Cycle 205 MPH/410 CFM GASOLINE POWERED BLOWERNAC Model No. 358.797290 Read and follow all Safety Rules and Operating WARNING: Instructions before first use of this product. For to your questions thispm, product: Call answers 7 am-7 pm, Mon.---Sat., or about 10 am-7 Sun. • 1-800-235-5878 Sears J_oebuck 530-087632 07/10/98 (.o==_._=._..=,_m) and Co.
I Warranty Statement Safety Rules Assembly Operation Maintenance Service & Adj_,stments - 2 2 4 6 8 9 Storage TroubleshootingChart Pads Ust Spanish Parts and Ordering 10 11 13 16 Back FULL TWO YEAR WARRANTY ON CRAFTSMAN ® GAS BLOWER Fo_o (2) years from date of purchasa, when this Gas Blower is maintained, lubncatad, and tuned up accordingto the instructionsin the operator's manual, Sears will repair, free of charge, any defects in material or workmanship.
• Wipe up fuel spills before starting engine. • Move at'least 10 feet (3 meters) away from fuel and fueling site before starting engine. OPERATE YOUR UNIT SAFELY • Stop the engine before Opening the vacuum inlet door.The engine must be stopped and the impeller blades no longer turning to avoid sedous injury from the rotatingblades. • Inspect unit bafom each use for worn, loose, missing,, or damaged parts. Do not use until unit is in proper working order. • Keep outside surfaces free from oil and fuel.
is not factory equipped with a spark arrestor;, however, a spark arrestor is available as an optional pad. If a spark arrestor is required in your area, contact Sears Service for the correct kit. Prclongeduse in cold we_ has been linkedto bloodvessel damage in otherwise healthypeopla.If _ occur such as n4mbnees,pa_, lossof strength,change in skincolor or texture, or lossof feelingin the fingers,hands, or joints,discontinuethe use of this tool and seek medicalattention.
• Align the lower vacuum tube as shown. Push lower vacuum tube into upper vacuum tube. Upper Lower Vacuum Tube • Insert a screwdriver intothe latch area on the vacuum inlet cover. .,p_.. Blower Outlet Latch Area Vacuum Inlet Cover • Gently tilt the handle of the screwdriver toward the back of the unit while pulling up on the vacuum inlet cover with your other hand. • Hold the vacuum inlet cover open until upper vacuum tube is installed. Vacuum Inlet Retaining Post Vacuum Inlet Cover .....
MULCHING BLADES t Your blower is equipped with mulching blades as a standard feature. When using the optionalvacuum attachment, the mulching blades automatically reduce debris at a ratio of up to 16:1. KNOW YOUR BLOWER READ THIS OPERATOR'S MANUAL AND SAFETY RULES BEFORE OPERATING Y4DURUNIT. Compare the illustrationswith your unit to familiarize yourself with the locationof the vadous controlsand adjustments. Save this manual for future reference.
tionsare _.00 a.m. to 5:00 p.m., Monday though Saturday. • To reduce noise levels, limit the number of pieces of equipment used at any one time. • To reduce noise levels, operate power blowers at the lowest _esib|e "throttle speed to do the job. • "Use rakes and brooms to loosen debrisbefore blowing. • In dusty conditions,slightlydampen surfaces or use a mister attachment when water is available.
property,or causingsedous Injuryto bystandersor the operator. STARTING A COLD ENGINE OR A WARM ENGINE AFTER RUNNING OUT OF FUEL • Move the throttle lever (_ to the fast ,r_ position. • Press the primer button (_) slowly 12 times. -_ ..... .. • Move the choke lever (_ tothe Pull Choke position. Throttle Lever _ Switch If the engine has not startsd after 5 pulls (at Half Choke), repeat the Starting a Cold Engine Procedure. If the engine stilldoes not =dart, proceed to Starting a Rooded Engine.
• On/Stsp Switch-Ensure On/Stsp switch prope,ly. Tostopen- gice, push and holdswitchin the STOP posen toacom- pleta stop. Make sure engine stops; then restartengineand continus. • • Fusl Tank- Do not ueeualt iffueltank showssignsofdemageorleaks. ° Optional Vacuum Bag - Do not use vacuum bag if it is tom or damaged. CLEAN UNIT & LABELS • Clean the uKItusing a damp cloth with a mild detergent. • Wipe off unit with a clean dry cloth.
•Tum the mixture screw counterclockwise until it stops. •Tum the idle speed screw clockwise until it stops. Now turn counterclockwise 4-1/2 turns. Start motor, let it run for 3 minutes, and proceed to the adjustment section. If engine does not start, refer to troubleshooting chart or call 1-800-235-5878. If engine performance is acceptabte at the preset positions, no further adjustments are necessary. Idle Speed Screw Mixture.
WARRANTY COMMENCEMENT DATE: The warranty period begins on the date the lawn and ;iardan equipment engine Is PUrchased. LENGTH OF COVERAGE: This warmntyehailbe forapadod oftwoyears from the Inl_ai date of purchase. WHAT IS COVERED, REPAIR OR REPLACEMENT OF YOUR WARRANTY RIGHTS AND OBLIGATIONS: The U. S. Environmental Protection PARTS. Repair or replacam.antof a.ny warAgencylCailfomta Air Resources Board and rented part Willbe penormeo at no charge to SEARS, ROEBUCKANDCO.
• At the beginnin_ of the next season, use only.fresh f0el having the proper gasoline to oil ratio. OTHER TROUBLESHOOTING • Do not store gasoline from one season to another. • Replace your gasoline can if it starts to rust. CHART TROUBLE CAUSE Engine will noLt• Engine flooded. start. ,, • Fuel tank empty. Spark plug notft tng. Fuel not reachin ] carburetor, • Compression low. REMEDY I " See =StartingInstructions." • Fill tank with correct fuel mixture. Install new Sl:ark plug.
' REPAIR PARTS SEARS MODELIS8.797290 AUNqxdn__l_n_nW and malm_mancenot de_rlbed • In the O_rlltm_ Manual mustbe perforatedbyqu4dlfled se_lce personnel. 242526 24 36 5 48 I 21 78910 20 18 I 17 35 9 15 31 78 18 23 11 37 4145 4039 14 12 47 27 28 16 29 32 U 1_46 Re. Pat No. 0w..puon Pot. PanNO. 2. 3, 4. 5. 6. 7. 8. g. 10. 11. 12. 13. 14. ,_.
REPAIR PARTS 34 3536 _37 31 36 33 47 " 36 17 36 2930 44 4 i 40 19 24 25 10 /-, 45 49 26 27 18 5 16 ,J _. _N_ 1. 2. 3. 4. 5. _I0015880 53006_32 E 53OO49488 N 9. 10. 11. 12. 13. 14. 15. 10, 17. _18, 19. 20. 21. 22. 23. 24, 530O15810 530015815 530019240 530029182 5300_17 530095461 ,S,_0015828 53062_ _._004_13 S304_2043 S3004,_9"/ 530019181 530049429 S300_12S 6300_124 530019179 530015945 5300_618 25. S3003S20S 26. 27. 5300_3817 530016180 _|cdptlon Ref. Parl NO. 28. 29.
REPAIR PARTS Carburetor K_ Aamm_blv Part Number P_ No. No. 1 2 3 $300_1403 t_069011 530069944. g30069924 - _NA229_ Descd_ion l.lmiter C_p taro. Repair Kit Gasket/okk Kit 2 Va_urrl "rum Aml'v. 3 Gutter Att_hrMnt 5 /-3 4 3 Kit IIg_-.TQ6812 -_ KEY NO. +PAR'[ NO. DESCRIPTION I 2 3 4 S 6 _ 5300_470 _._095589 5,_049686 530049485 830095468 Va¢ Bag w/Strap Elbow-Vat Tube LowerTube CI_p-Va¢Tube Knob-Vat Tube Upper Tube Kl_lr I _o.i 15 mg /-s nn PART .o.
For the repair or replacement parts you need delivered 'directly to your home Call 7 am - 7 pm, 7 days a week 1-800-366-PART (1-800-366-7278) I Para ordenar p|ezas con entrega a domi¢ilio - 1-800-659-7084 t For in-home major brand repair service Call 24 hours a day, 7 days a week 1-800-4-REPAIR (1-800-473-7247) Para pedir servicio de reparaci6n a domicilio - 1-800-676-5811 For the location of a Sears Parts and Repair Center in your area Call 24 hours a day, 7 days a week 1-800-488-1222 nmmmmm muummm
