Operator`s manual

ASSEMBLY
If unit is received assembled, repeat all steps in this section to be sui-e assembly is correct,.
PREPARATION
This Operator's Manual is designed to help you _semble mad safely operate the unit. It is important that you read the
entiremanual tobecome familiarwith theunitbeforeyou beginassembly.
TOOLS NEEDED FOR ASSEMBL_ StandardScrewdriver,PhillipsScrewdri_,er,Pliers.
iiiiiiiii •- i iiiiiiiHll Jill
A.TUBE ASSEMBLY
1. Remove and discard the plastic inserts (3) found in
the tubes. Figure I (inset).
2. Lay motor housing/tube assembly on a flat surface,
3. Locate the two indentations at{he end of the lower
tube,Alignthelowerindentationwiththemotor
housingasshown inFigureI,
4. Insertthe lowertube intothe uppertube (Fig-
ure t ) and align screw holes.
5. Insert the twn screws, one at a time, through the
aligned •holes. Figure I. Thread locknut onto
screwsand tightensecurely.
6, Remove theroundhead,screwandhex nutlocated
at the top of the motor housingwitha Phillips
screwdriver,Figure2.
7. S]idetheexcesswireintothetopofthemotorhvus.
ing. Figure 2.
Tl_eexcesswi_ must slidedown beyond the
areaofthemotorhousingwherelowextubeenters,
8. Slidethelowertubeintothemotor housingasfar
asitwillgo (about3inches)and alignindentations
withscrewopenings.
9. Installtheround head screwand hexnutremoved
instep6. and theround head screwand hex nut
from thecarton.Figure2. Tightensecurely.
•NOTE." Be sure to install the screws in the round re-
cesses and the nutsinthe hex recesses.
. :_ HHHHI I HHI ],i................H.,
B.ASSIST HANDLE ATTACHMENT
I. FirmlypushAssistHandle ontotube,Figure3,
2. Hold theunitintheoperatingposition.Adjust,the
handle up ordown thetubetoa positioncom2ort-
ablefortheuser.
3. Pass the Hex Head Screw through the hole in the
A_sistHandle, F_re 3, Thread the Wing Nut
ontothescrewand tightensecurely.
_ The recommended position is thatwhich:
1)allowsyou toholdtheassisthandlecomfortably
in the left band,and
2) places the trimmer head just dear the ground.
• See Figure 6. , :
......................... , ,,.H HHHUI L , III I HHI
NOTES
,,if i i i fill i i •
Inserts _ Lower Lower Motor
Upper Screws Tube IndentationHousing]
Trigger" %
Handle Locknuts
Figure 1
"-. Lower "
_ IndentationHex Nu{s
Motor
Figure 2
HH INHI I m,,IH HHNI
Screw
Assist
Handle
•Wing Nut
Fibre3
• HI it i _ii i
-6-