Operator`s manual

C. PR_E-OPERATION CHECKS
,=ufRevle---I _" WARNING
=
Warnings and Safety Instructions in
Ithis manual
• Before operating your tool, alwmys:
1. Inspect the entire tool before each use. Re-
place damaged parts, Make sureallfastenersarein
placeand securelyfastened,
ii HIll i
D.EXTENSION CORD ATTACHMENT
1. Use only a 120 A.Co voltage supply as shown on
the nameplate of the unit to power your blower.
2. The extension cord used to reach the power
source must be:
Specifically marked as suitable for out-
dooruse. Yhe cord mu_t be marheoLwizh the s_f-
f_ 'T/A"
b. Heavy enough to carry the current from
the power source the full length Of the ex-
tension cord to the u_Lit. Otherwise, toss of
powerand overheatingcan occur_usingdamage
to the unit. Refer to Figure 4 for mi_um wire
g_uge recommendations. The cor_ must be
markedwith_lzeproperw_egazz_ (Appropriate
extension cords are available.}
c. In good condition. Cord insulation must be in-
tact with no cracks or deterioration. Plugc0nnec-
tors must be undamaged.
3. Secure extension cord to the Cord Retainer
as shown in Figure 5.
4. Inser_ the cord socket into the recessed plug on the
unit. Figure 5.
2. Replace trimmer he_d parts that are cra_
• chipped, broken, or damaged in any other way be-
fore usingthetool.'
3. Use onl_ .08G"diameter line.Neverusewire,
rope,string,etc.
4. Use only the speeifiedtrimmer head. See
Specifications."Make surethetr_m_erheadis
[Foperlyinstalledand securelyfastened.Referto
Using Your Unit."
5. Use only genuine SEARS accessories or at-
tachments recommended forthistool.
ii ....i !Hi,,ii ii HI
WIRE GAUGE
RECOMlV[ENDATIONS
VOLTS ] 2._E I 50_PI_ '] 100F'_
120 I8 16 16
A.W.G.= A.W.G.* •A.W.G.°
•A_._=w_._ Figure 4
Recessed
Cord
Socket
Figures
• J,l,
E, OPERATING POSITION
ql iii i
Before operating the unit, stand as shown in
• Figure 6 and check for the following:
a. Operator wearing eye, leg, and foot protection.
b. Right arm slightly bent, hand holding handle.
c. Leftarm straight,hand holdingassisthandle,
d. Unitbelowwaistlevel
e. Without operator bending ov_ the Trimmer
Head is near and parallel to the ground and eas.
i_y contacts the material to be cut.
,,,,,,,,,,,,,,,,,,,, ,,,,,,,,,,,
POSmON
on
H_a_ 6
iii _ji
NOTES
-7-